Oven light replacement (on some models), Awarning, A caution – GE JGBP27DEMWW User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
GEAppliances.com
Stainless Steel Surfaces
ion som e m odels)
Do not use a steel wool pad; it will scratch the
surface.
This will help you to maintain the brightness
and appearance of your stainless steel range.
■ In order to avoid any discolorations and/or
grease stains, we recommend cleaning and
removing any spills, spots and grease from
the range after use.
■ It is important to use a soft cloth or paper
towel every time the range is cleaned to
avoid any scratches.
Read carefully the instructions on the back of
the Brightener for better results.
Cleaning Instructions:
1.
Remove grates.
2. Wash using warm, soapy water:
Wet soft cloth or paper towel (avoid using
excessive water).
Wipe the surface in the direction of the grain
(following the steel lines).
Rinse and wring out a soft cloth or paper
towel and dry the range.
3. Apply a degreaser that does not contain
sodium hydroxide or stainless steel cleaner
(follow instructions).
4. Repeat steps 2-4 as many times as needed.
5. Put grates back in place.
Follow these instructions for any stainless steel
surface on your range.
DO NOT USE for cooktop or stainless steel
parts cleaning:
•
Caustic lye (sodium hydroxide) or cleaners
containing this chemical
• Hard or steel wool pads
• Abrasive materials or chemicals
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the
location of a dealer nearest you, please call our
toll-free number:
National Parts Center 800.626.2002 (U.S.)
800.661.1616 (Canada)
GEApplianceParts.com (U.S.)
AWARNING
Shock or Burn Hazard: Before replacing oven light bulb, disconnect the electrical power to the
range at the m ain fuse or circuit breaker panel. Failure to do so m ay result in electric shock or burn.
Oven Light Replacement
(on som e m odels)
Be sure to let the light cover and bulb cool
Replace bulb with a 40-watt appliance
completely.
bulb or two-prong halogen bulb, as
To remove the cover:
appropriate.
|“g Twist lens counterclockwise about a
To replace the cover.
quarter turn to remove.
Do not rem ove any screws to rem ove the cover.
m
Oven Light Replacement
(on som e m odels)
A CAUTION
Before replacing
your oven light bulb, disconnect the electrical
power to the range at the m ain fuse or circuit
breaker panel. Be sure to let the light cover
and bulb cool com pletely.
The oven light bulb is covered with a remov
able glass cover that is held in place with a
bail-shaped wire. Remove the oven door, if
desired, to reach cover easily.
To remove:
Line up tabs of lens in front of tabs on
housing and rotate clockwise to engage.
Do not remove any screws to remove
the cover.
0
0
Hold a hand under the cover so it
doesn't fall when released. With fingers
of the same hand, firmly push back the
wire cover holder. Lift offthe cover.
Do not touch hot bulb with a wet cloth.
Replace bulb with a 40-watt household
appliance bulb.
To replace cover:
Place it into the groove ofthe light
receptacle. Pull the wire forward to the
center ofthe cover until it snaps into
place. When in place, the wire holds the
cover firmly. Be certain the wire is in the
depression in the center ofthe cover.
Connect electrical power to the range.
33