To begin steam clean cycle, Acaution, Using steam clean – GE JGBP27DEMWW User Manual

Page 35: Steam, On some models), Start, Clear

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Using Steam Clean,

(on some models)

GEAppliances.com

ACAUTION

During the steam clean cycle,

the oven bottom becomes hot enough to cause burns.

Wait until the cycle is over (30 minutes) before wiping

the inside surfaces ofthe oven. Failure to do so may
result in burns.

The Steam Clean cycle makes It easier to clean light soil from
the porcelain oven Interior and door glass.

The range should be at room temperature before begin­

ning the Steam Clean cycle. Ifthe oven is too hot, "Hot" will
appear on the display and the cycle will not activate until the
oven cools down.

The Steam Clean cycle performs best on new spills or soils.

Burned-on food is more difficuitto remove.

floor.

C

steam |

Clear^

G

Start~^

On

J

G

Clear^

OffJ

To Begin Steam Clean Cycle:

|~^ Remove racks and accessories from the

oven cavity. Do not place cookware or
other items in the oven during the Steam
Clean cycle.

Pour 1 cup (8 oz.) room-temperature

water ontothe recessed area ofthe oven

bottom. Do not add cleaning solutions or
chemicals of any kind to the water. Do not
pour water down the burner slots on oven
bottom.

Close the door.

Press the

Steam Clean

pad; then press

Start/On.

^ A 30-minute cycle will begin to count

down on the display.

When the Steam Clean cycle is complete,
the oven control will beep and the

Steam

Clean

light will blink. Press the

Clear/Off

pad and open the door.

'Y]

The oven bottom and remaining water

will still be very warm at the end of the
cycle. This is normal.

^ Remove soils using a scrub brush or nylon

scouring pad. A soap-filled steel wool pad
may be used only on the porcelain oven
interior.

The use ofabrasive pads will

scratch the doorglass.

Do not wipe soil

or water onto the door gasket.

pi Remove any remaining water with a dry

cloth or sponge.

^ Leave the door open to air dry.

IMPORTANTNOTES:

Ifa steam clean cycle is initiated without

water, press the

Clear/Off

pad

to end the

cycle. Wait for the range to cool to room

temperature before pouring water into
the recessed area and initiating another

steam cycle.

• DonotopenthedoorduringtheSteam

Clean cycle. An error beep will sound upon
opening the door.

• Press

Clear/Off

pad

at any time to end the

cycle.

• If mineral deposits remain in the oven bot­

tom after cleaning, use a cloth or sponge

soaked in vinegar to remove them.

• Some water may drip from the bottom of

the oven door. Ifthis happens, wipe it up at
the end ofthe cycle.

• Thedoorgasketmaybewetwhenthe

Steam Clean cycle finishes. This is normal.

Do not clean the gasket.

• If soil still remains after cleaning the oven,

see the

Care and Cleaning ofthe Range

section ofthe Owner's Manual for addi­

tional options.

35

Advertising