Carrier 336 - Manual (Page 19)

15 Models 336, 338 & 339 Operating Procedures
Slide the fork over the bar in the slot of the draw valve.
Secure with pivot pin.
Note: The Models 336, 338 and 339 have three draw
handles. Slide the fork of the draw handle in the slot of
the draw valve, starting from the right. Slide the pivot
pin through each draw handle as you insert them into
the draw valves.
Figure 14
Note: These units feature adjustable draw handles to
provide the best portion control. The draw handles can
be adjusted for different flow rates. See page 11 for
more information on adjusting these handles.
Step 7
Snap the design caps over the end of the door spouts.
Figure 15
Step 8
Install the front drip tray and the splash shield under
the door spouts.
Figure 16
Step 9
Slide the rear drip pan into the hole in the side panel
(front panel on a Model 338).
Figure 17
Step 10
Slide two o-rings on one end of the air tube. Slide two
o-rings on the other end of the air tube.
Figure 18