KORG Soundlink DRS REcording Console 168RC - Manual (Page 32)

19. Recalling a program
18. Saving a program
The settings of all paranaeters except for the analog section, MIDI mode, and the CLK Source
setting of MISC mode can be saved (stored) as one of up to 99 programs "01"~"99". Program "00"
is read-only. These programs can be recalled whenever desired.
There are two ways in which a program can be saved and (as explained in the section below)
recalled. One method is to use PGM mode. In this case, a program list will appear, allowing you to
see the program that is selected (“S" p.34). The other method is to use the [SAVE] key and [RE­
CALL] key. In this case, you can recall or save from any mode other than PROGRAM mode or
MIDI mode, making the operation quicker. Here we will explain how to save using the [SAVE]
key.
О Press the [SAVE] key. The program number will go blank.
-pt PGM Chi >In/S
Auxl Aux2 Effl Eff2
О О О О
Q о Q
Post Post Pre
Pan
Use the [SEL] keys to input the save destination number. The channel 1 [SEL] key will input 1,
the channel 2 [SEL] key will input 2,... and the channel 10 [SEL] key will input 0. You must
input a two-digit number.
If the program is locked, the display will indicate "¡Protected," and saving will not be possible.
Either turn off locking in PGM mode, or save the program to a different number.
Press the [SAVE] key. The program number will be finalized, and the program update mark
will change to a indicating that the program has been saved. To cancel without saving,
press the [PGM] key. With this procedure, it is not possible to modify the name of the program.
7 9. Recalling a program
Here we will explain how to use the [RECALL] key to recall a program. Refer to "18. Saving a
program."
O Press the [RECALL] key. The program number will turn blank.
0 Use the [SEL] keys to input the number of the program that you wish to recall. The channel 1
[SEL] key will input 1, the channel 2 [SEL] key will input 2,... and the channel 10 [SEL] key will
input 0. You must input a two-digit number.
O Press the [RECALL] key. The program number will be finalized, and the program name will
change. To cancel without recalling, press the [PGM] key.
25