KORG Soundlink DRS REcording Console 168RC - Manual (Page 93)

Chapters. Reference
2. Troubleshooting
Nothing appears in the LCD when the [POWER] switch is
pressed
• Is the power cable connected to an AC outlet?--------------------------------------------------------------- (p.8)
No sound
' Are the external devices connected correctly?----------
’ Is a signal selected for input to the mixer channel? ■
' Are the channel faders raised?------------------------------
' Is MUTE turned on?--------------------------------------------
• Is SOLO turned on for the channels which do not output sound?-------------
Have the BUS Assign settings been made correctly to send signals to the
master L/R and group buses?
(p.l6,82-85)
- (p.9, 35,39)
---------- (p.4)
------(p.4,35)
------(p.4, 35)
• Are the group bus volume and "ON/OFF" switches set correctly? -
• Is the signal that you wish to output to Monitor selected correctly?
Is the [TAPE IN/MONITOR] switch set correctly?
(p.lO, 38)
(p.lO, 44)
(p.lO, 44)
------ (p.6)
------ (p.6)
' Are the levels of the [MONITOR] knob and [PHONES] knob raised?
Sound does not disappear
• Is the Input Sel. setting causing a signal to be input to an internal bus?--------------------------- (p-29)
• Is SOLO turned on?---------------------------------------------------------------------------------------------- (p.4,35)
• Is the [TAPE IN/MONITOR] switch set correctly?--------------------------------------------------------- (p.6)
Noise is heard
• Is an unconnected audio input selected in Input Sel?---------------------------------------------------- (p-29)
• Is the CLK Source set correctly?------------------------------------------------------------------ (p.l7, 27,82-85)
Sound is distorted
• Are the [PAD] key and the [TRIM] knob set correctly? —
• Is the [PHANTOM power] switch set correctly?--------------
• Is the fader (level) raised excessively? -
' Is the equalizer gain raised excessively?-------------------------------------
(Either lower the gain, or use EQ Pad to lower the input level.)
' Is the Output Level of an internal effect raised excessively?----------
-- (p.3)
-- (p.7)
-(p.4,35)
--(p.36)
-(p.46-74)
Phase is wrong
• Is the phase of the input device set correctly? - (p.35,39)
Operating a fader does not change the volume
• Perform the "fader hooking" operation.--------------------------------------------------
Is channel pairing turned on?
• Are the System Extension settings correct?---------
Cannot exchange data via MIDI
• Are the MIDI cables connected correctly?-----------
■ ---- (p.4)
-(p.4,27)
(p.30, 77)
' Are the System Extension settings correct?--------------------------------------------
' Do the MIDI channels of the transmitting and receiving devices match? .
’ Are the Program Change No. settings correct?---------------------------------------
-(p.30-33, 75-78, 85)
------------ (p.30,77)
-(p.30-33, 75-78, 85)
------------------ (p.31)
Cannot transfer digital audio
• Are the cables connected correctly?-------------------
• Check the items listed above under "No sound.'
• Is the CLK Source set correctly?------------------------ (p.l6,82-85)
-(p.86)
-(p.l7,27, 82-85)
86