KORG Soundlink DRS REcording Console 168RC - Manual (Page 42)

5
.
1/S/P mode
5. I/S/P mode
Input/Send/Pan (Chi...Chi
2
)
Here you can select the input source for each channel, and set phase, pan, and the various send
levels. Use the [SEL] keys to select channels.
Input "DIG-Al ...DIG-A8, DIG-Bl ...DIG-B8, ANA-A...ANA-H"
Select the channel input source. You can choose from the following 24 audio inputs.
"DIG-A1...DIG-A8" of adat OPTICAL IN A
"DIG-B1...DIG-B8" of adat OPTICAL IN B
"ANA-A...ANA-H" of INPUT A~ and LINE IN E~H
The meter indicates the post-fader level.
Phase SW " o (phase normal),
<f>
(phase inverted)"
This inverts the phase of the channel input. If an audio device with a connector that inverts the hot
and cold connections is input in stereo, the spatial image may be indistinct, or some portions of
the sound may be canceled. In such cases, the phase switch can be used to invert the phase. The
phase is inverted when the " ^ " symbol is displayed.
Auxl, Aux2, Eff 1, Eff2 "0... 100", "Post, Pre"
These settings set the levels that are sent respectively to the Auxl, Aux2, EFFl and EFF2 buses.
You can also specify whether the signal that is sent will be taken from before (Pre) or after (Post)
the fader.
Pan "L50...L01, CNT, ROl ...R50"
Specify the stereo location of the signal that is sent to master L/R or to.the group bus (when a
stereo group is selected).
Input/Send/Pan (Ch
1 3
...Ch
1 6
)
Auxl Aux2 Effl Eff2
o o o o
Pan LEUL
o a
Post Post Pre Post solo mute
If a chaimel 13-16 is selected, the following parameters will be added to the contents of "Input/
Send/Pan (Chl...Chl2)" discussed above.
Each time you press the left-most [SEL] key, you will step through channels 13-16.
LEVEL "0...100"
This setting functions as the fader. The "y" symbol at the upper right of the knob indicates the 0 dB
position. A value of "70" corresponds to 0 dB.
Solo SW "solo, SOLO"
This switches the solo fimction on/off. A display of "solo" is off, and "SOLO" is on. This status is
also indicated by the solo indicator at the upper right of the LCD (p.l2).
Mute SW "mute, MUTE"
This switches the mute fimction on/off. A display of "mute" is off, and "MUTE" is on.
35