Chorus, 09; chorus – KORG Soundlink DRS REcording Console 168RC User Manual
Page 59
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Chapter 4. Effects
09: Chorus
This is a stereo-output harmonic chorus. The left and right LFOs can be biased to control the
spaciousness.
If0 TYPE
Triangle, Sine '
Select the LFO waveform.
LFO PHSE
-180...+180 deg
Set the phase difference between the left and right LFOs.
If the phase of the LFOs is biased, modulation will be ap
plied to the left and right "out of step" with each other. This
will produce a more spacious feeling, and the processed
sounds in the left and right will "beat" against each other.
52
LFO FREQ
0.02... 15.0 Hz
Set the LFO speed.
DPTH
0...100
Set the modulation depth of the LFO.
W/D
Dry,!...99, Wet
Set the balance between the effect processed sound and
the direct sound.
PreDLAY
0...200mS
Set the delay time after the direct sound.
FBAK
-100...+100
Set the amount of feedback for the chorus block. Raising
the feedback will produce a flanging effect.
DAMP
0...100
Set the amount of high frequency attenuation for the cho
rus block.
Split FREQ
100Hz...10.0kHz
Set the frequency at which the low and high frequencies
will be split. Only the high frequency range will be sent to
the chorus block.
Split LOW
0...100
Set the output level of the low frequency range.
Split HIGH
0...100
Set the output level of the high frequency range (the cho
rus sound).