KORG Soundlink DRS REcording Console 168RC - Manual (Page 81)

Chapter 4. Effects
31: Overdrive-Amp Sim. (Overdrive-Amp Simulator)
After being sent through an overdrive effect, the sound is sent through an effect that simulates the
sonic characteristics of a guitar amp. This is especially effective when used on sounds such as
guitar or organ.
OVD
MIX
Amp TYPE
Output PAN
Output LEVI
Bandi FREQ
Bandi 0
Bandi GAIN
Band2FREQ
Band2 Q
Band2GAIN
0...100
0...50
SS,EL84,6L6
L50...L01,CNT,
R01...R50
0...100
100Hz..10.0kHz
0
.
6
...
8.0
-
12...+12
lOOHzJO.OkHz
0
.
6
...
8.0
-
12...+12
Set the amount of distortion.
The amount of distortion is determined by the level of the
input signal itself in conjunction with the OVD setting.
Raising OVD will raise the overall volume, so use Output
LEVL to adjust the volume. Output LEVL will also be the
input level to the 2-Band EQ. If clipping occurs in the 2-
Band EQ, adjust Output LEVL.
Set the amount of direct sound that will be mixed into the
distortion sound.
Select the type of guitar amp.
Set the pan position of the output.
Set the output level.
Set the center frequency of equalizer band 1.
Set the frequency width of equalizer band 1. Higher set­
tings of this value will make the band sharper and more
narrow.
Set the gain of band 1.
Set the center frequency of equalizer band 2.
Set the frequency width of equalizer band 2. Bandl Q
Set the gain of band 2.
74