KORG Soundlink DRS REcording Console 168RC - Manual (Page 40)

3. MIDI mode
Send Parameter (Send Param)
$
FADERSMUTE EFFECT
EQ BUS MASTER
PAH SHD MASTER
BUS
INPUT
SEND]_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
OTHERS
All Param.
[EXIT]
Here you can transmit the current settings of the 168RC for the specified category (the highlighted
selection) as control change messages («s’ p.92). When MIDI Type is "Control Change" or "NRPN"
the settings will be transmitted as the respective type of MIDI message, and when it is "Off" or
"Exclusive" they will not be transmitted. If the data is transmitted as Control Change messages, it
will also follow the Parameter Number settings.
O Use a MIDI cable to connect the MIDI OUT of the transmitting device to the MIDI IN of the
receiving device.
e Set the transmitting and receiving devices to the same MIDI (Tx Base Ch, Rx Base Ch) channel
setting.
0 If this 168RC is the receiving device, set it to the same MIDI Type as the transmitting device. In
addition, if MIDI Type is "Control Change", you must also set the same Parameter Number.
O Use the [ /\ ]/[ \/ ] keys to highlight the type of settings that you wish to transmit.
0
Press knob [1] ("[Send]"), and the messages will be transmitted. If you press knob [8] ("[EXIT]"),
you will return to the MIDI Menu page.
Send Exclusive
set PGM Chi >Exclusi'-.'e
All ^ta
Current PGM
All EQ Memory
Current EQ
SEND]
All EFF Memory
Current EFF
Here you can transmit the current settings of the 168RC for the specified category (the highlighted
selection) as system exclusive messages. For this operation, the messages that are transmitted will
not be affected by the MIDI Setup setting.
By recording these messages on an external sequencer etc. for later re-transmission to the 168RC
when necessary, you can backup the internal memory. This function also provides a way in which
two or more 168RC units can be set to the same memory contents.
All Data : Transmit all parameters including All PGM Memory, All EQ Memory,
All EFF Memory, Current PGM, and all parameters including MIDI mode
and CLK Source of MISC mode.
: Transmit parameters for programs P.OO—P.99.
: Transmit the parameters of the currently selected program.
: Transmit parameters for EQ 01—30.
; Transmit the parameters of the currently selected EQ.
: Transmit the parameters for effects 01—50.
: Transmit the parameters of the currently selected effect.
O Use a MIDI cable to connect the MIDI OUT of the transmitting device to the MIDI IN of the
receiving device.
0
Set the transmitting and receiving devices to the same device ID setting.
0
If this 168RC is the receiving device, set MIDI Type to "Exclusive".
O Use the [ /\ ]/[ V ] keys to highlight the type of settings that you wish to transmit.
0
Press knob [1] ("[Send]"), and the messages will be transmitted. If you press knob [8] ("[EXIT]"),
you will return to the MIDI Menu page.
A
While data is being transmitted or received by Send Exclusive, panel operations will be ig­
nored.
All PGM Memory
Current PGM
All EQ Memory
Current EQ
All EFF Memory
Current EFF
33