D.A.S. Audio DASnet V1.5 - Manual (Page 36)

DASnet - 36
- Load monitoring: for each amplifier channel there is an impedance system control that
indicates if the speakers are working (green) or not (red):
On the “advanced view” parameters as gain/delay/preset/polarity/mute and solo are available:
- Gain control: this control is for the complete cabinet (not per amplifier channel). From -20dB
to +6dB. Value can be entered using the keyboard or the gain control of the software.
- Delay control: this control is for the complete cabinet (not per amplifier channel). From 0ms
to 34ms.
- Presets: on the LX-218CA_net two presets are available: Front and Rear
- Polarity: inverts the polarity of the complete cabinet.
- Mute/Solo: per amplifier channel or per cabinet. When SOLO is activated ALL the other
devices on the net are muted.
advanced device view window
delay control
gain control
presets control
When the cabinet´s knob is pressed rear preset is active. Rear preset
must be used only when cabinet is facing backguards in conjunction with
other ones facing to the front to create a caridoid subwoofer set up.
F
R
CARDIOID