D.A.S. Audio DASnet V1.5 - Manual (Page 37)

Preset changes are bidirectional so if a preset is changed on the software it will be also changed
on the cabinet. And vice versa, a change on the cabinet will be shown as well on the software.
IMPORTANT: all DASnet control parameters (gain, delay, presets, mute, solo...etc) are stored on
the micro controller included in the amplifier. This means that after switching off the system all values
of the parameters will remain the same in memory for the next time the system is switched on.
For instance: if a cabinet has these settings Gain +6dB, delay 15.038ms:
When it is switched off all values are saved in the internal micro controller memory, so next time
the system is powered the parameters remain the same Gain +6dB, delay 15.038ms.
IMPORTANT: when the user is not sure about the internal settings in the micro controller (delay,
gain etc) the best thing is to do a factory settings reset. Factory settings puts all the parameters
at zero. Device name will remain the same (in this case LX-2056). Front preset will be active.
Factory settings reset can be done via software: (check that gain and delay are set up at zero)
But also physically by pressing the preset knob (holding during a few seconds) while powering
the cabinet.
DASnet - 37