Hazard warning flashers, Turn and lane-change signals, Hazard warning flashers on – GMC 2012 Sierra User Manual

Page 205: Hazard warning flashers -5 turn and lane-change, Signals -5

Advertising
background image

Black plate (5,1)

GMC Sierra Owner Manual - 2012 - CRC - 11/15/11

Lighting

6-5

If the vehicle is not equipped
with DIC buttons, exit lighting is
automatic. When it is dark enough
outside, the exterior lamps remain
on for 30 seconds after the ignition
is moved from ON/RUN to
LOCK/OFF.

For vehicles without a radio, the
instrument panel light remains on for
30 seconds with the driver door
closed. For vehicles with a radio,
the instrument panel light remains
on for 10 minutes with the driver
door closed. See Retained
Accessory Power (RAP) on
page 9‑29
.

The regular headlamp system can
be turned on when needed.

Hazard Warning Flashers

|

(Hazard Warning Flashers):

Press this button located on top of
the steering column, to make the
front and rear turn signal lamps
flash on and off. This warns others
that you are having trouble. Press
again to turn the flashers off.

When the hazard warning flashers
are on, the vehicle's turn signals will
not work.

Turn and Lane-Change
Signals

An arrow on the instrument panel
cluster flashes in the direction of the
turn or lane change.

Move the lever all the way up or
down to signal a turn.

Raise or lower the lever for less
than one second until the arrow
starts to flash to signal a lane
change. This causes the turn
signals to automatically flash
three times. It will flash six times
if tow-haul mode is active.

Advertising