Golden Lighting 1323-1W WG - Manual

Assembly Instructions: 1323-1W WG (Ella)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the important
notes above. Shut off the power at the circuit breaker and
completely remove the old fixture from the wall, including the
old mounting strap.
Mounting strap (B) contains several pairs of threaded holes.
Find the pair of holes that matches the spacing of the holes on
the junction box and your fixture back plate. Note: In order for
the fixture to hang straight, brackets (C) should be centered at
the top and bottom. Pull the house wires through the center
of mounting strap (B), place mounting strap (B) over the
junction box so that mounting screws (A) are horizontal, and in
alignment with the hole locations on the fixture backplate (F).
Secure mounting strap (B) to the junction box with mounting
screws (A) and a screwdriver. Tighten the screws securely.
CONNECTING THE WIRES
Attach the fixture’s wires to the power supply wires from the
junction box. Connect black to black (or smooth); white to
white (or ribbed); ground to ground (green or copper). Twist the
ends of the wire pairs together, then twist on a wire connector.
Make sure all twists are in the same direction. If there is no
ground wire (green or copper) from the junction box, locate
ground screw (E) on mounting strap (B) and wrap the fixture
ground wire around the green ground screw (E). Use a
screwdriver to secure ground screw (E) onto the mounting
bracket. Tuck all wires neatly into the junction box.
FINISHING THE INSTALLATION
Place fixture backplate (F) over brackets (C) of mounting
strap (B) and line up the holes on the top and bottom of the
backplate with the holes in brackets (C). Insert screws (D) into
the holes at the top and bottom of backplate (F) and use a
screwdriver to tighten the screws securely.
Slide candle sleeve (J) over socket (I).
Install the light bulb (K) (not provided) in accordance with the
fixture’s specifications. Hang crystal (G) to post (H).
Your installation is now complete. Turn on the power and test
the fixture.
CLEANING TIPS
Treat the fixture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down
the fixture with a clean lint-free cotton or microfiber cloth. Never spray cleaner directly onto the fixture.
For Customer Service, contact
the place of purchase to arrange
for replacement parts.
BLACK
(Hot)
WHITE
(Neutral)
GREEN
(Ground)
HOUSE WIRES
SMOOTH
(Or Black)
FIXTURE WIRES
RIBBED
(Or White)
BARE COPPER
(Or Green)
E
A
B
D
C
F G
H
I
J
K