Golden Lighting 1425-3P WG - Manual

1ea ∅5-1/2"*H1-1/8" 2ea 8#32-IP*1" 1ea 1/8-IP*H3-1/4"
1ea 6ft ∅3.8 3ea P3 Orange 1ea 1/4-IP*H55mm
2ea ∅5.8*H61mm 1ea ∅1-1/4"*H42mm 1ea W4-1/8"*E1"*H5mm
5ea ∅3-3/8"*H15mm
Part Needed Quantity
Part Needed Quantity
Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments
Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are
missing or damaged, please note onthis sheet and contact the place of purchase to arrange for replacement
parts.
PARTS LIST Company Name:_______________________Co. Account #:_____________
to be filled out by retailer
PARTS & ASSEMBLY SHEET
Fixture Name: Sancerre 1425-3P WG
This fixture assembled PO:__________ Date: ________
F IXTURE A SSEMBLY I NSTRUCTIONS
Read and review installation instruction sheet before
assembling the fixture.
1425-3P WG
ASSEMBLING THE FIXTURE (Fig.1)
1. Straighten the wires and pass them through Nipple
(S), Spacer (R), Square Tube (Q), Spacer (P), Center
Rod Column (O). Push Center Rod Column (O) down
over Spacer (P), through the center of the frame, and
over Spacer (R). Twist Center Rod Column (O) to
tighten onto Nipple (S).
2. Pass Spacer (N) over Nipple (M) and screw on Top
Loop (J) until tight.
Fig 1
NOTE: I NSTALL THE GLASS ASSEMBLY AFTER
THE FIXTURE IS HUNG.
For Customer Service, contact the place of purchase to arrange for replacement parts.
Canopy Mounting Screws Top loop
Chain Wire connectors Nipple
5ea ∅1"*3-3/8"
Chain connector
Canopy loop
with Collar
Mounting strap
Iron Tube crystal bobeche