Golden Lighting 1821-SF BI - Manual

Mounting strap
(circular)
Wire connectors Deco nut
1ea @4" 4ea P3 Orange 2ea 12mm
Canopy
Junction box
screw
Top loop
1ea @5-1/2"X1-1/4" 2ea 8/32" x 1" 1ea 53 x 56mm
Chain Mounting screw
1ea 6ft x3.8mm 2ea 8/32" x 22" 2ea @3/8 x 40mm x 5mm
Chain connector Hex nut Nipple
2ea @3X38mm 1ea @3/8 x 50mm
Mounting strap
w/ ground screw
1ea 3/4"X4"
Part Needed Quantity
Part Needed Quantity
Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments
Fig. 1
PARTS & ASSEMBLY SHEET
1821-SF BI
Read and review installation instruction sheet before
assembling the fixture.
F IXTURE A SSEMBLY I NSTRUCTIONS
This fixture assembled PO:__________ Date: ________
Fixture Name: Madera 1821-SF BI
Canopy loop
with Collar
Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or
damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts.
PARTS LIST
Company Name:_______________________Co. Account #:_____________
to be filled out by retailer
For Customer Service, contact the place of purchase to arrange for replacement parts.
ASSEMBLING THE FIXTURE as Semi flush (Fig. 1)
1. Thread the Stem With Hex Nut (N) into the bottom coupling of
the Fixture body (M) until tight.
2. Slide the Flat Washer (O), Rubber Washer (P), Glass shade (Q),
Rubber Washer (P) and Frame (R) over the Stem With Hex Nut
(N), secure in place with the Hex nut (R). Slide the Bottom cap (T)
over the Stem With Hex Nut (S), secure in place with the Finial (U).
3. Install the light bulbs in accordance with the fixture's
specifications.
(DO NOT EXCEED MAXIMUM WATTAGE RATING)
2ea/1ea @3/8 x 3mm/ @3/8 x 5mm
Q
P
O
N
M
P
U
T
S
R