Golden Lighting 2049-4P FB - Manual (Page 2)

INSTALLATION INSTRUCTIONS
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
Fixture Name: Valencia 2049-2W FB
For Wall Mount Light Fixture
For Customer Service, contact the place of purchase to arrange for replacement parts.
Fig. 3
Fig. 1
Fig. 2
HANGING THE FIXTURE (Fig. 1)
1. Carefully remove the new fixture from the carton and the
yellow bag that holes all your parts. Check that all parts are
included as shown in the illustration and parts list.
2. Shut off power at the circuit breaker and remove the old
fixture from wall, including the old mounting strap.
3. Thread other end of the Nipple (C) with Canopy Loop
attached into Mounting Strap (D).
4. Take this mounting strap assembly and mount to ceiling
junction box with Mounting screws (E). Tighten screw securely
with screw driver.
CONNECTING THE WIRES (Fig. 2)
5. Attach the power supply wires to the fixture lead wires by
connecting BLACK to BLACK (or SMOOTH) and WHITE to
WHITE (or RIBBED).
6. Ground wire connection: Connect fixture ground wire to
supply ground wire (usually with green insulation) with wire
connector. If there is no supply ground wire at ceiling juction box
then attach fixture ground wire securely onto green grounding
screw located at mounting bar.
NOTE: Twist the wires together in the same direction you twist
the wire connector onto the wires.
7. Tuck these wire connections neatly into the Junction Box.
FINISHING THE INSTALLATION (Fig. 3)
8. Place the fixture Back Plate (K) over the Nipple (C), so it
protrudes through the hole in the Back Plate (K)
9. Thread the Deco Nut (I) onto the Nipple (C) and continue
turning until the Back Plate (K) is snug against the wall.
10. Install light bulbs in accordance with the fixture's
specifications.
YOUR INSTALLATION IS NOW COMPLETE.
RETURN POWER TO THE JUNCTION BOX AND TEST THE
FIXTURE.
HOUSE WIRES
WHITE
BLACK
RIBBED (WHITE)
SMOOTH (BLACK)
FIXTURE WIRES
C
E
B A
JUNCTION BOX
(CEILING)