Golden Lighting 2073-FM - Manual

Assembly Instructions: 2073-FM (Smyth)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the important
notes above. Shut off the power at the circuit breaker and
completely remove the old fixture from the ceiling, including
the old mounting strap.
Mounting strap (B) contains several pairs of threaded holes.
Find the pair of holes that matches the spacing of the holes
on the junction box. Two of mounting screws (A) should be
attached to mounting strap (B). You may need to tighten the
nuts (C) that hold these screws in place. Place mounting
strap (B) over the junction box so that mounting screws (A)
are pointing down. Secure mounting strap (B) to the junction
box with mounting screws (D) and a screwdriver. Tighten the
screws securely.
CONNECTING THE WIRES
Have an assistant or assistants support the fixture weight
while completing the wiring. Cut away excess wire. Attach
the fixture’s wires to the power supply wires from the junction
box. Connect black to black (or smooth); white to white (or
ribbed); ground to ground (green or copper). Twist the ends of
the wire pairs together, then twist on a wire connector. Make
sure all twists are in the same direction. If there is no ground
wire (green or copper) from the junction box, locate ground
screw (E) on mounting strap (B) and wrap the fixture ground
wire around the green ground screw (E). Use a screwdriver to
secure ground screw (E) onto the mounting bracket. Tuck all
wires neatly into the junction box.
FINISHING THE INSTALLATION
Raise the top of fixture body (G) to the ceiling. Position
mounting screws (A) so that they protrude through the
openings of fixture body (G). Secure the top of fixture body
(G) to the mounting strap by screwing decorative nuts (F) onto
mounting screws (A). Tighten securely.
Install light bulbs (H) (not included) in accordance with the
fixture’s specifications.
Your installation is complete. Turn on the power and test the
fixture
.
For Customer Service, contact the
place of purchase to arrange for
replacement parts.
CLEANING TIPS
Treat the fixture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
fixture with a clean lint-free cotton or microfiber cloth. Never spray cleaner directly onto the fixture.
D
C
B
A
E
H
F
G
BLACK
(Hot)
WHITE
(Neutral)
GREEN
(Ground)
HOUSE WIRES
SMOOTH
(Or Black)
FIXTURE WIRES
RIBBED
(Or White)
BARE COPPER
(Or Green)