Golden Lighting 2073-LP WG - Manual (Page 2)

F For Customer Service, contact the place of purchase to arrange for replacement parts.
2073-LP GMT INSTALLATION INSTRUCTIONS PART 1
INSTALLATION INSTRUCTIONS
Fixture Name: SMYTH 2073-4 GMT
For Pendant Light Fixture
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
HANGING THE FIXTURE (Fig.1)
1. Carefully remove the new fixture from the carton and the
yellow bag that holds all parts. Check that all parts are
included as shown in the illustrations and the Parts List.
2. Shut off the power at the circuit breaker and remove the
old fixture from ceiling, including the mounting strap.
3. Place Lock Washer (B) over end of Nipple (C) which should
protrude through Mounting Strap (D). Thread Hex Nuts (A)
onto nipple (C) until tight.
4. Take this mounting strap assembly and mount to ceiling
Junction Box with Junction Box Screws (E). Tighten screw
securely with screw driver.
5. Assembly the fixture and have an assistant or secure a
support to hold the weight of the fixture while you complete
the wiring connections.
6. Thread the fixture wires and ground wire of the assembled
fixture through the chain loops, Canopy Loop (F), Nipple
(C) and up into the Junction Box.
CONNECTING THE WIRES (Fig.2)
7. Attach the power supply wires to the fixture lead wires by
connecting BLACK to BLACK (or SMOOTH) and WHITE to
WHITE ( or RIBBED) .
8. Ground wire connection: Connect fixture ground
Wire to supply ground wire (this usually has green
insulation) with wire connector. If there is no supply
ground wire at ceiling junction box then attach fixture
ground wire securely onto the green grounding screw
located at mounting bar.
NOTE: Twist the wires together in the same direction you
twisted the wire connector onto the wires.
9. Tuck these wire connections neatly into the ceiling
Junction Box.
10. Place the fixture Canopy (F) over the nipple (C) and
secure Canopy (F) against the ceiling by threading Nut (G)
over the Nipple (C) until tight.
11. Install the light bulbs and glass shade as per the Parts and
Assembly Sheet.
Fig. 1
Fig.2
YOUR INSTALLATION IS NOW COMPLETE.
RETURN POWER TO THE JUNCTION BOX
AND TEST THE FIXTURE
FIXTURE
WIRES
SMOOTH
(Or Black)
RIBBED
( i )
HOUSE
WIRES
BLACK
(Hot)
WHITE
E
D
JUNCTION BOX
(CEILING)
A
C
B
H
F
G