Golden Lighting 2073-M1L WG - Manual

For Customer Service, contact the place of purchase to arrange for replacement parts.
2073-M1L GMT PARTS AND ASSEMBLY SHEET
PARTS & ASSEMBLY SHEET
This fixture assembled PO: Date:
Fixture Name: SMYTH 2073-M1L GMT
Notice: Please review the Parts List and check for all parts before assembling the fixture. If any
parts are missing or damaged, please note on this sheet and contact the place of purchase to
arrange for replacement parts.
PARTS LIST
Company Name:______________ Co Account#:__________
below to be filled out by retailer
Mounting Strap
Φ
102 ㎜ 1ea
Green Screw
G8/32*H8 ㎜ 1ea
Mounting Screws
H32 ㎜ 2ea H38 ㎜ 2ea
Wire Connectors
Orange 3ea
Hex Nut
G5/32*H4 ㎜ 2ea
Deco Nut
Φ
12*12 ㎜ 2ea
Canopy 1ea
L126*W126*H25 ㎜
12” Rod Φ 12*L305
㎜
3ea
6” Rod Φ12*L152 ㎜
1ea
Part Needed ______________________________ Quantity _________________________________
Part Needed ______________________________ Quantity _________________________________
Reason why (missing, scratched, broken glass, bent, bad finish)
Comments __________________________________________________________________________
FIXTURE ASSEMBLY INSTRUCTIONS
Read and review installation instruction sheet
before assembling the fixture
2073-M1L GMT
Fig.1
1.
Measure to determine the correct number of
rods needed for proper hanging height. There
are 3 optional 12" rods and a 6” rod included.
2. To shorten the fixture, trim the wires to the
desired length and add at least 8~10 inches.
You must use at least the 6” rod.
3. To lengthen the fixture, add additional rods.
(ROD-12 CDB) is available. To purchase
additional rods, please contact the retailer.
4. Pull the fixture’s wires through the rods.
5. Place Washer (G) between Rod (H) and
Frame (I). Thread Rod (H) into Frame (I) until
tight.
6. Place Washer (G) between each rod and
thread until tight.
7. Feed the fixture wires through Canopy (E)
and pull the wires until taut.
8. Thread Canopy (E) into Rod (H) until tight.
E
F
G
H
I