Golden Lighting 2073-SF WG - Manual

Assembly Instructions: 2073-SF (Smyth)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the important
notes above. Shut off the power at the circuit breaker and
completely remove the old fixture from the ceiling, including the
old mounting strap.
Mounting strap (B) contains several pairs of threaded holes.
Find the pair of holes that matches the spacing of the holes
on the junction box. Two of mounting screws (A) should be
attached to mounting strap (B). You may need to tighten the
nuts (C) that hold these screws in place. Place mounting strap
(B) over the junction box so that mounting screws (A) are
pointing down. Secure mounting strap (B) to the junction box
with mounting screws (D) and a screwdriver. Tighten the screws
securely.
Place the fixture body on a flat surface. Rod (N) is on the fixture
wires, but not attached to the body of the fixture. Pass the
fixture wires through Rod (N) and pull the wires until taut. Twist
rod (N) onto the fixture body until secure. Attach rods (M) to the
hooks on the fixture body. Have an assistant hold the canopy
above the fixture body, then attach rod (N) to canopy (F). Attach
rods (M) to the hooks on canopy (F). Push the wires through the
center of canopy (F).
CONNECTING THE WIRES
Have an assistant or assistants support the fixture weight
while completing the wiring. Cut away excess wire. Attach the
fixture’s wires to the power supply wires from the junction box.
Connect black to black (or smooth); white to white (or ribbed);
ground to ground (green or copper). Twist the ends of the wire
pairs together, then twist on a wire connector. Make sure all
twists are in the same direction. If there is no ground wire (green
or copper) from the junction box, locate ground screw (E) on
mounting strap (B) and wrap the fixture ground wire around the
green ground screw (E). Use a screwdriver to secure ground
screw (E) onto the mounting bracket. Tuck all wires neatly into
the junction box.
FINISHING THE INSTALLATION
Raise canopy (F) to the ceiling. Position mounting screws (A) so
that they protrude through the openings of canopy (F). Secure
canopy (F) with decorative nuts (G).
Slide candle sleeves (Q) over the sockets. Install light bulbs (O)
(not included) in accordance with the fixture’s specifications.
Place glass shade (S) onto bottom cap (T). Raise glass shade
up beneath bottom assembly (R). Twist bottom finial (U) onto the
threads of bottom assembly (R). Tighten securely.
Your installation is complete. Turn on the power and test the
fixture
.
For Customer Service, contact the
place of purchase to arrange for
replacement parts.
CLEANING TIPS
Treat the fixture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
fixture with a clean lint-free cotton or microfiber cloth. Never spray cleaner directly onto the fixture. For deep cleaning, turn off the light
and remove the glass prior to cleaning. Hand wash glass with warm water and mild detergent. Dry with a lint-free or microfiber cloth.
D
C
B
A
S
T
U
M
N
P
O
Q
E
F
G
R
FLUSH
INSTALLATION
BLACK
(Hot)
WHITE
(Neutral)
GREEN
(Ground)
HOUSE WIRES
SMOOTH
(Or Black)
FIXTURE WIRES
RIBBED
(Or White)
BARE COPPER
(Or Green)