Golden Lighting 2074-BA5 CH - Manual

Assembly Instructions: 2074-BA3/4/5 CH (Smyth II)
IMPORTANT:
• All InStAllAtIon work Should be done by AccredIted profeSSIonAl.
• Shut off power Supply At fuSe or cIrcuIt breAker!
• uSe only the SpecIfIed bulbS. do not exceed the mAxImum wAttAge!
PRePARINg fOR INsTAllATION
remove all of the contents from the carton. See the important
notes above. Shut off the power at the circuit breaker and
completely remove the old fixture from the wall, including the
old mounting strap.
Mounting strap (B) contains several pairs of threaded holes.
Find the pair of holes that matches the spacing of the holes on
the junction box and your fixture backplate. Two of mounting
screws (A) should be attached to mounting strap (B). You
may need to tighten the nuts that hold these screws in place.
Pull the house wires through the center of mounting strap
(B), place mounting strap (B) over the junction box so that
mounting screws (A) are horizontal, and in alignment with
the hole locations on fixture backplate (F). Secure mounting
strap (B) to the junction box with mounting screws (D) and a
screwdriver. Tighten the screws securely.
CONNeCTINg THe WIRes
Attach the fixture’s wires to the power supply wires from the
junction box. Connect black to black (or smooth); white to
white (or ribbed); ground to ground (green or copper). Twist
the ends of the wire pairs together, then twist on a wire
connector. make sure all twists are in the same direction. If
there is no ground wire (green or copper) from the junction
box, locate ground screw (E) on mounting strap (B) and wrap
the fixture ground wire around the green ground screw (E). Use
a screwdriver to secure ground screw (E) onto the mounting
bracket. Tuck all wires neatly into the junction box.
fINIsHINg THe INsTAllATION
Place fixture backplate (F) over mounting screws (A) so that
they protrude through the holes in the front of the backplate.
Thread deco nuts (G) onto mounting screws (A). Twist until the
backplate of the fixture is snug against the wall.
Install the provided halogen bulbs in accordance with the
fixture’s specifications.
bulb note: use a tissue or paper towel to hold the bulb and
push the bulb down into the socket. oils and dirt can cause
the bulb life to shorten. Rubbing alcohol is recommended for
cleaning the bulbs.
Slide glass shades (H) over the sockets and twist to secure in
place.
your installation is now complete. turn on the power and test
the fixture.
CleANINg TIPs
Treat the fixture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down
the fixture with a clean lint-free cotton or microfiber cloth. Never spray cleaner directly onto the fixture. For deep cleaning, turn off the
light and remove the glass prior to cleaning. Place the glass shades aside to clean one at a time. Hand wash glass with warm water
and mild detergent. Dry with a lint-free or microfiber cloth.
BLACK
(Hot)
WHITE
(Neutral)
GREEN
(Ground)
HOUSE WIRES
SMOOTH
(Or Black)
FIXTURE WIRES
RIBBED
(Or White)
BARE COPPER
(Or Green)
for Customer service, contact
the place of purchase to arrange
for replacement parts.
B
C
D
G
H
E
A
F