Golden Lighting 3030-BA1 CH - Manual

Mounting Strap
1 ea
Ø
3/4*1"
Junction Box Screw
2 ea
#8-32N*H25mm
Thread Rod
1 ea
3/8"*H50mm
Wire Connector
3 ea
P3
Hex Nut
2 ea
3/8"*H3mm
Deco Nut
1 ea
3/8"-
27N*H12mm
Green Ground Screw
1 ea
#8-32N*H10mm
Spring Washer
1 ea
Ø
15*H3mm
Spacer
1 ea
Ø
2
5*H26mm
Xenon Bulb
1 ea 14*13*44MM
Socket Tool
Φ28*127MM
Part Needed Quantity
Part Needed Quantity
Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments
PARTS & ASSEMBLY SHEET
This fixture assembled PO:__________ Date: ________
Fixture Name: Vanora 3030-BA1 CH
Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are
missing or damaged, please note o n this sheet and contact the place of purchase to arrange for replacement
parts.
PARTS LIST
Company Name:_______________________Co. Account #:_____________
below to be filled out by retailer
3030 BA1-CH
Read and review installation instruction sheet before
assembling the fixture.
F IXTURE A SSEMBLY I NSTRUCTIONS
For Customer Service, contact the place of purchase to arrange for replacement parts.
1. Place fixture Back Plate (P), over
Threaded Rod (D), so that it protrudes through the hole in
Back Plate (P).
2. Thread Deco Nut (I) onto Threaded Rod (D)
and continue turning until Back Plate (P) is snug
against the wall .
3. Slide Outer Glass Shade (J) on over Socket (H). (Note: The
gap at the bottom of the glass should be turned toward inside.)
Then, slide Inner Glass Shade (K) and Spacer (L) over Socket
(H). Secure Outer Glass Shade (J), Inner Glass Shade (K), and
Spacer (L) in place using Socket Tool (O) to thread Socket Ring
(M) onto the Socket (H) until tight.
4. Install the Light Bulb (N) in accordance with the
fixture's specifications.
(DO NOT EXCEED THE MAXIMUM WATTAGE
RATING!)
Fig. 4
220V 25W
G9
H
I
J
K
L
M
N
P
O