Golden Lighting 3071-BA2 GG - Manual (Page 2)

FINISHING THE INSTALLATION (Fig. 3)
8. Raise the assemble light fixture to the wall so that it covers the
junction box. 9. Line
the screw holes up on both sides of Mounting Strap (A) with the
holes of the fixture's backplate. 10. Secure
the backplate of the light fixture to the junction box using the four
small screws. Tighten the screws securely using a screw driver.
YOUR INSTALLATION IS NOW COMPLETE.
RETURN POWER TO THE JUNCTION BOX AND TEST THE
FIXTURE.
Fig. 3
INSTALLATION INSTRUCTIONS
Fixture Name: ATHENA 3071-BA1/2/3/4/ GG
For Wall Mount Light Fixture
For Customer Service, contact the place of purchase to arrange for replacement parts.
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
HANGING THE FIXTURE (Fig. 1) 1.
Carefully remove the new fixture from the carton and the yellow
bag that holds all of your parts. Check that all parts are included as
shown in the illustrations and on the Parts and Assembly Sheet.
2. Shut off the power supply at the circuit breaker and remove the
old fixture from the ceiling, including the old mounting strap.
3. Place Mounting Strap (B) over the junction box. 4.
Attach Mounting Strap (B) to the junction box using the two
Mounting Screws (A). Tighten the screws securely using a screw
driver.
Fig. 1
CONNECTING THE WIRES (Fig. 2)
5. Attach the power supply wires to the fixture lead wires by
connecting BLACK to BLACK (or SMOOTH) and WHITE to
WHITE (or RIBBED). 6.
Attach the GROUND wire (GREEN or COPPER) from the junction
box and the fixture Ground wire to the green Ground Screw on
Mounting Bracket (A) or connect both wires together using the
correct size of wire connectors. NOTE:
Twist the wires together in the same direction that you twist the
wire connectors onto the wires. 7. Tuck
these wire connections neatly into the Junction Box.
Fig. 2
BARE COPPER
(Ground)
GREEN
(Ground)
FIXTURE WIRES
SMOOTH (BLACK)
RIBBED (WHITE)
BLACK
WHITE
HOUSE WIRES
A B
A B
H
G
F
E
C
D