Golden Lighting 3890-BA3 GB - Manual

INSTALLATION INSTRUCTION WM-1
For Wall Mount Light Fixtures (Rev.2/7/95) For Wall Mount Light Fixtures (Rev.2/7/95) For Wall Mount Light Fixtures (Rev.2/7/95) For Wall Mount Light Fixtures (Rev.2/7/95)
PREPARATION
1.
Shut off power at the fuse box or circuit breaker box.If
necessary ,remove old fixture and all moumting hardware
from wall junction box.
2.
Carefully unpack your new fixture and lay out all the parts
on a clear area.Take care not to loose any small parts
Necessary for installation.
MOUNTING THE FIXTURE
3.
Your new fixture will be either a Circular Strap(Fig.A)
mounting , or a Crossbar (Fig .B) mounting type.
Determine which type your fixture is by the parts shipped
with your fixture and follow the appropriate instruction.
NOTE:The wining is the same for either fixture.
Fig.A CIRCULAR STRAP MOUNTING
A1.The Circular Strap(A)contains several pairs of threaded
holes , Find the pair of holes that match the hole spacing
in your fixture Canopy (D) and thread the two Studs(C)
Part Way into the Circular STRAP(A).
A2. Place the circular Strap(A) over the junction box so the
Studs (C) are vertical or horizontal, as required by fixture
Type.Holding the Strap in place ,secure to the junction
Box by thredaing the two junction box screws(B)
through the slotted holes.
A3. Connect the wires as described under Connecting
the wires.
A4. Place the fixture Canopy(D) over the two Studs(C) so
they protrude through the holes in the Canopy(D)
Thread the Capnuts(E) onto the Studs(C) and continue
turning until the Fixture is snug against the wall.(See)
Completing the installation”
Fig.B CROSSBAR MOUNTING
B1.Attach the Crossbar(A) to the junction box with the two
junction box screws(B) as shown.The side of the
Crossbar marked “GND” must face out.
B2. Thread the Nipple (C) part way into the center hole of the
Crossbar.
B3. Connect the wires as described under “Connecting the
wires”
B4. Place the fixture Canopy(D) over Nipple so the Nipple
Protrudes through the center hole.Holding the fixture in
place .thread the Capnut(E) onto the end of the Nipple
until fixture is secure to the wall (See “Completing the
installation”)
WAR NI N G! SHU T POW ER OF F AT FU SE OR C IR C UIT BRE AKE R
CONNECTING THE WIRES
Connect the fixture wires to the junction box wires
as Shown in the wiring diagram.Make sure all wire
connectors are secure and do not easily pull off
with a slight tug.if there is no Green Ground wire
from the junction box, concent the Fixture Ground Wire
to the Circular Strap or the Crossbar with the Green
Screw prowided.
COMPLETING THE INSTALLATION
4.Install the Glass Shades(F) to the Holders(G) and
finger tighten the three set screws per each holder
5.Install the proper light bulbs for your fixture.DO
NOT EXCEED THE SPECIFIED WATTAGE!
Return the power to the junction box and test the
1.
Fixture.Your installation is now complete.
JUNCTION BOX
(CEILING)
A
C
B
D
E
F
G
CIRCULAR STRAP
CROSSBAR
G
F
E
D
B C
A
JUNCTION
BOX