Golden Lighting 4002-BA4 RSB - Manual (Page 2)

INSTALLATION INSTRUCTION WM-1
For Wall Mount Light Fixtures
PREPARATION
1. Shut off power at the fuse box or circuit breaker box.
If necessary, remove old fixture and all mounting
hardware from wall junction box.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts Necessary for installation.
MOUNTING THE FIXTURE
3. Your new fixture will be either a Circular Strap (Fig.A)
mounting, or a Crossbar (Fig.B) mounting type.
Determine which type your fixture is by the parts
shipped with your fixture and follow the appropriate
instruction.
NOTE: The wiring is the same for either fixture.
Fig. A CIRCULAR STRAP MOUNTING
A1.The Circular Strap (A) contains several pairs of
threaded holes, Find the pair of holes that match the
hole spacing in your fixture Canopy (D) and thread
the two Studs(C) Part Way into the Circular Strap (A).
A2. Place the circular Strap (A) over the junction box so
the Studs (C) are vertical or horizontal, as required by
fixture Type. Holding the Strap in place, secure to the
junction Box by threading the two junction box
screws (B) through the slotted holes.
A3. Connect the wires as described under Connecting the
wires.
A4. Place the fixture Canopy (D) over the two Studs(C)
so they protrude through the holes in the Canopy (D)
Thread the Cap nuts (E) onto the Studs(C) and
continue turning until the Fixture is snug against the
wall. (See) Completing the installation”
Fig. B CROSSBAR MOUNTING
B1.Attach the Crossbar (A) to the junction box with the
two junction box screws (B) as shown. The side of the
Crossbar marked “GND” must face out.
B2. Thread the Nipple (C) part way into the center hole of
the Crossbar.
B3. Connect the wires as described under “Connecting the
wires”
B4. Place the fixture Canopy (D) over Nipple so the
Nipple Protrudes through the center hole. Holding the
fixture in place .thread the Cap nut (E) onto the end of
the Nipple until fixture is secure to the wall (See
“Completing the Installation”)
CONNECTING THE WIRES
Connect the fixture wires to the junction box wires as
Shown in the wiring diagram. Make sure all wire
connectors are secure and do not easily pull off with a
slight tug. If there is no Green Ground wire from the
junction box, connect the Fixture Ground Wire to the
Circular Strap or the Crossbar with the Green Screw
provided.
COMPLETING THE INSTALLATION
4. Install the Glass Shades (F) to the Holders (G) and
finger tighten socket ring (H).
5. Install the proper light bulbs for your fixture. DO
NOT EXCEED THE SPECIFIED WATTAGE! Turn
the power on at the junction box and test the fixture.
6. Your Fixture installation is now complete.
CSKLG002
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER