Golden Lighting 4002-M1L RSB - Manual (Page 2)

INSTALLATION INSTRUCTION CH-1
For Chandelier Light Fixtures (Rev.07-02-07)
HANGING THE FIXTURE（Fig.1）
1. Shut off the power at the circuit breaker and remove
old fixture from ceiling, including the old crossbar.
2. Carefully unpack new fixture and lay all the parts
on a clear surface.
3. Thread nipple (C) into loop (F) until snug.
4. Thread other end of nipple (C) with loop attached
into crossbar (D) until snug.
5. Place lock washer (B) over of nipple protruding
through crossbar and thread hex nuts (A) onto
nipple until tight.
6. Take this crossbar assembly and mount to ceiling
junction box with junction box screws (E) .Tighten
screw securely with screwdriver.
7. Use a pair of pliers to open one end link (I) of the
chain provided, and connect to the fixture loop (J).
Close the link.
8. By measuring, determine correct number of links
needed for proper hanging height. Using pliers
disconnect and discard remaining chain.
9. Lace the fixture wires through the chain.
10. Slip loop collar (H) over the chain, then do the same
with the canopy (G).
11. Open the other end link (I) of the chain and hang
the fixture on the loop at the ceiling. Close the link.
12. Feed the fixture wires through the loop (F), and
nipple (C) and pull until taut.
CONNECTING THE WIRES (Fig.2)
13. Take the black wire from the ceiling junction box
and the smooth wire leg from the fixture and twist
bare ends together. Twist wire connector onto end
of wires until snug.
14. Repeat same process with white junction box wire
and ribbed wire of fixture.
NOTE: Twist wires together in the same direction
you twist the wire connector onto wires.
15. If your junction box has a grounding wire (green or
bare copper), attach this wire and the bare copper
wire from the fixture together as in step 13. If
junction box has no ground wire, attach the bare
copper fixture wire to the junction box with a screw.
16. Tuck these wire connections neatly into the ceiling
outlet box and then raise the canopy (G) all the way
to the ceiling. Raise the loop collar (H) and thread
onto ceiling loop protruding through canopy.
17. Install the light bulbs in accordance with the
fixtures specifications.
NOTE: DO NOT EXCEED THE SPECIFIED
WATTAGE.
Your installation is now complete. Turn power on at
to the junction box & test the fixture.
CSKLG003
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER