Golden Lighting 4444-BA1 PW - Manual (Page 2)

For Wall Mount Light Fixture
INSTALLATION INSTRUCTIONS
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
Fixture Name: Nelio 4444-BA1 PW
For Customer Service, contact the place of purchase to arrange for replacement parts.
Fig. 3
Fig. 1
Fig. 2
HOUSE WIRES
WHITE
BLACK
RIBBED (WHITE)
SMOOTH (BLACK)
FIXTURE WIRES
J
H
I
M
K
L
GN
D
A I C B
G F D E
JUNCTION BOX
HANGING THE FIXTURE (Fig. 1)
1.Carefully remove the new fixture from the carton and the
yellow bag that holds all your parts. Check that all parts
are included as shown in the illustration and parts list.
2. Shut off power at the circuit breaker and remove the old
fixture from wall, including the old mounting strap.
3.Take Threaded Rod (D) from parts bag and thread into
center screw hole on Mounting Strap (A), tighten with Hex
Nut (B) and Spring Washer (C).
4. Attach the Mounting Strap (A) to the Junction Box (I)
using the two Mounting Screws (E). Tighten the screws
securely.
CONNECTING THE WIRES (Fig. 2)
5. Attach the power supply wires to the fixture lead wires
by connecting BLACK to BLACK (or SMOOTH) and
WHITE to WHITE (or RIBBED).
6. Attached the GROUND wire (GREEN or COPPER)
from the Junction Box and the fixture Ground wire to the
green Ground Screw on the Mounting Strap (B) or
connect both wires together using the correct size of wire
connectors
NOTE: Twist the wires together in the same direction you
twist the wire connector onto the wires.
7. Tuck these wire connections neatly into the Junction
Box.
FINISHING THE INSTALLATION (Fig. 3)
8. Place the fixture Back Plate (K) over the Thread Rod
(D),so it protrudes through the hole in the Back Plate (K).
9. Thread the Deco Nut (M) onto the Threaded Rod (D)
and continue turning until the Back Plate (K) is snug
against the wall.
10. Install glass as per the fixture assembly instructions.
YOUR INSTALLATION IS NOW COMPLETE. RETURN
POWER TO THE JUNCTION BOX AND TEST THE
FIXTURE.