Golden Lighting 5050-M1L CH - Manual

Assembly Instructions: 5050-M1L CH (Danica)
IMPORTANT:
• All InstAllAtIon work shoulD be Done by AccreDIteD professIonAl.
• shut off power supply At fuse or cIrcuIt breAker!
• use only the specIfIeD bulbs. Do not exceeD the mAxImum wAttAge!
PRePARINg fOR INsTALLATION
carefully remove all of the contents from the carton. see the
important notes above. shut off the power at the circuit breaker
and completely remove the old fixture from the wall, including
the old mounting strap.
Mounting strap (B) contains several pairs of threaded holes. Find
the pair of holes that matches the spacing of the holes on the
junction box and your fixture backplate. Two of mounting screws
(A) should be attached to mounting strap (B). You may need to
tighten nuts (C) that hold these screws in place. Pull the house
wires through the center of mounting strap (B). Place mounting
strap (B) over the junction box so that mounting screws (A) are
vertical, and in alignment with the hole locations on canopy (F).
Secure mounting strap (B) to the junction box with mounting
screws (D) and a screwdriver. Tighten the screws securely.
By measuring, determine the correct amount of decorative
chain (K) and cable wire (L) needed for proper hanging height.
To shorten the fixture, trim the wires to the desired length plus
at least 8 to 10 inches. unhook and discard any unwanted
decorative chain (K). Put the wire through nipple (H) of canopy
(f).
CONNeCTINg THe WIRes
Have an assistant support the fixture weight while completing
the wiring. Cut away any excess wires. Thread the fixture wires
through canopy (F). Attach the fixture’s wires to the power
supply wires from the junction box. Connect black to black (or
smooth); white to white (or ribbed); ground to ground (green or
copper). Twist the ends of the wire pairs together, then twist on
a wire connector. make sure all twists are in the same direction.
If there is no ground wire (green or copper) from the junction
box, locate ground screw (E) on mounting strap (B) and wrap
the fixture ground wire around the green ground screw (E). Use
a screwdriver to secure ground screw (E) onto the mounting
bracket. Tuck all wires neatly into the junction box.
fINIsHINg THe INsTALLATION
Push canopy (F) up to the ceiling so that mounting screws (A)
protrude through the holes in canopy (F). Secure canopy (F)
to the ceiling by tightly threading decorative nuts (G) onto the
screws. slide shade (J) over socket (I) and secure in place with
socket ring (K).
Install the light bulbs (not included) in accordance with
the fixture’s specifications. Do not exceed the maximum
recommended wattage.
your installation is now complete. turn on the power and test
the fixture.
CLeANINg TIPs
Treat the fixture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
fixture with a clean lint-free cotton or microfiber cloth. Never spray cleaner directly onto the fixture.
for Customer service, contact
the place of purchase to arrange
for replacement parts.
I
J
K
A
D
B
C
E
L
M
G
F
H