Golden Lighting 6390-BA3 WG - Manual

Assembly Instructions: 6390-BA3 WG (Coronada)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
CLEANING TIPS
Treat the fixture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
fixture with a clean lint-free cotton or microfiber cloth. Never spray cleaner directly onto the fixture.
For Customer Service, contact
the place of purchase to arrange
for replacement parts.
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the important notes
above. Shut off the power at the circuit breaker and completely
remove the old fixture from the wall, including the old mounting
strap.
Mounting strap (B) contains several pairs of threaded holes. Find the
pair of holes that matches the spacing of the holes on the junction
box and your fixture back plate. Two of mounting screws (A) should
be attached to mounting strap (B). You may need to tighten the
nuts that hold these screws in place. Pull the house wires through
the center of mounting strap (B). Place mounting strap (B) over
the junction box so that mounting screws (A) are horizontal, and in
alignment with the hole locations on the fixture backplate (F). Secure
mounting strap (B) to the junction box with mounting screws (D) and
a screwdriver. Tighten the screws securely.
CONNECTING THE WIRES
Attach the fixture’s wires to the power supply wires from the junction
box. Connect black to black (or smooth); white to white (or ribbed);
ground to ground (green or copper). Twist the ends of the wire pairs
together, then twist on a wire connector. Make sure all twists are in
the same direction. If there is no ground wire (green or copper) from
the junction box, locate ground screw (E) on mounting strap (B) and
wrap the fixture ground wire around the green ground screw (E). Use
a screwdriver to secure ground screw (E) onto the mounting bracket.
Tuck all wires neatly into the junction box.
FINISHING THE INSTALLATION
Place fixture backplate (F) over mounting screws (A) so that they
protrude through the holes in the front of the backplate. Thread
deco nuts (G) onto mounting screws (A). Twist until backplate (F) of
the fixture is snug against the wall.
Note: Complete the remaining steps after the fixture is hung.
Install the provided halogen bulbs (H) into sockets (I).
Bulb Note: Use a tissue or paper towel to hold the bulb and push
it down into the socket. Oils and dirt can cause the bulb life to
shorten. Rubbing alcohol is recommended to clean dirty bulbs.
Carefully slide glass shades (L) over sockets (I). The glass shade
openings are tight. Carefully push diffusers (J) which are attached
to diffuser bottoms (K) down into glass shades (K) and over the
sockets. Twist the glass diffusers onto the socket threads. This will
secure the glass in place.
Your installation is now complete. Turn on the power and test the
fixture.
BLACK
(Hot)
WHITE
(Neutral)
GREEN
(Ground)
HOUSE WIRES
SMOOTH
(Or Black)
FIXTURE WIRES
RIBBED
(Or White)
BARE COPPER
(Or Green)
B
E
D
A
C
G
F
J
K
L
H
I