Golden Lighting 8063-1W BUS - Manual

For Wall Mount Light Fixture
INSTALLATION INSTRUCTIONS
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
Fixture Name: Heartwood 8063-1W BUS
Fig. 3
Fig. 1
Fig. 2
For Customer Service, contact the place of purchase to arrange for replacement parts.
HANGING THE FIXTURE(Fig.1)
1.Carefully remove the new fixture from the carton and the
yellow parts bag. Check that all parts are included as shown in
the illustration and parts list.
2. Shut off power at the circuit breaker and remove the old
fixture from wall, including the old mounting strap.
3.The Mounting Strap(F) contains several pairs of threaded
holes, find the pair of holes that match the holes spacing in your
fixture Back Plate(S) and thread the two Fixture Mounting
Screws(D) half way into the Fixture Mounting Strap(F) and
secure with Hex Nut (G).
4. Place the Mounting Strap(F)over the Junction Box so the
Fixture Mounting Screws(D) are vertical or horizontal, as
required by the fixture type.
CONNECTING THE WIRES (Fig 2)
6. Attach the power supply wires to the fixture lead wires by
connecting BLACK to BLACK (or SMOOTH) and WHITE to
WHITE (or RIBBED).
7. Attach the GROUND wire(GREEN or COPPER) from the
Junction Box and the fixture Ground wire to the green Ground
Screw on the Mounting Bracket (I) or connect both wires
together using the correct size of wire connectors.
NOTE:Twist the wires together in the same direction you twist
the wire connector onto the wires.
8. Tuck these wire connections neatly into the Junction Box.
FINISHING THE INSTALLATION(Fig.3)
9. After tucking these wire connections neatly into the Junction
Box and place the fixture Back Plate(S) over the two Mounting
Screws(D) and secure the Back Plate(S)against the wall by
threading two Deco Nuts(O) over the two Mounting Screws(H)
until tight as shown on Fig.3.
10. Install glass as per the fixture assembly instructions.
YOUR INSTALLATION IS NOW COMPLETE. RETURN
POWER TO THE JUNCTION BOX AND TEST THE FIXTURE.
5. Attach the Mounting Strap(F) to the Junction Box using the
two mounting screws(H). Tighten the screws(H) securely with
screw driver.