Golden Lighting 8063-3P BUS User Manual

Installation instruction ch-1

Advertising
background image

INSTALLATION INSTRUCTION CH-1

For Chain Hung Light Fixtures (Rev.

For Chain Hung Light Fixtures (Rev.

For Chain Hung Light Fixtures (Rev.

For Chain Hung Light Fixtures (Rev.07

07

07

07----02

02

02

02----07

07

07

07))))



HANGING THE FIXTURE

Fig.1


1.

Shut off the power at the circuit breaker and remove old

fixture from ceiling, including the old crossbar.

2.

Carefully unpack new fixture and lay all the parts on a clear

surface.

3.

Thread nipple (C) into loop (F) until snug.

4.

Thread other end of nipple (C) with loop attached into cross-

bar (D) until snug.

5.

Place lock washer (B) over of nipple protruding through

crossbar and thread hex nuts (A) onto nipple until tight.

6.

Take this crossbar assembly and mount to ceiling junction

box with junction box screws (E) .Tighten screw securely
with screwdriver.

7.

Use a pair of pliers to open one end link of the chain

provided, and connect to the fixture loop (J). Close the link.

8.

By measuring, determine correct number of links needed for

proper hanging height. Using pliers disconnect and discard
remaining chain.

9.

Lace the fixture wires through the chain.

10.

Slip loop collar (H) over the chain, then do the same with the

canopy (G).

11.

Open the other end link of the chain and hang the fixture on

the loop at the ceiling. Close the link.

12.

Feed the fixture wires through the loop (F), and nipple (C)

and pull until taut.


CONNECTING THE WIRES (Fig.2)

13. Take the black wire from the ceiling junction box and the

smooth wire leg from the fixture and twist bare ends
together.

Twist wire connector onto end of wires until snug.
14.

Repeat same process with white junction box wire and

ribbed wire of fixture.

NOTE: Twist wires together in the same direction you twist
the wire connector onto wires.
15.

If your junction box has a grounding wire (green or bare

copper), attach this wire and the bare copper wire from the
fixture together as in step 13. If junction box has no ground
wire, attach the bare copper fixture wire to the junction box
with a screw.

16.

Tuck these wire connections neatly into the ceiling outlet

box and then raise the canopy (G) all the way to the ceiling.

Raise the loop collar (H) and thread onto ceiling loop
protruding through canopy.
17.

Install the light bulbs in accordance with the fixtures

specifications.
NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE.
Turn power on at the junction box & test the fixture.
Your installation is now complete


WAR NI NG! SHU T POWER OF F AT FUSE OR CIRCUI T BREAKER

D

E
F

H

J

CHAIN

G

A

JUNCTION BOX
(CEILING)

B

C

2

Advertising