Golden Lighting 8063-SF BUS - Manual

INSTALLATION INSTRUCTION CH-1
)RU &KDLQ +XQJ /LJKW )L[WXUHV 5HY  )RU &KDLQ +XQJ /LJKW )L[WXUHV 5HY  )RU &KDLQ +XQJ /LJKW )L[WXUHV 5HY  )RU &KDLQ +XQJ /LJKW )L[WXUHV 5HY 
HANGING THE FIXTURE ᧤Fig.1᧥
1. Shut off the power at the circuit breaker and remove old
fixture ftom ceiling, including the old crossbar.
2. Carefully unpack new fixture and lay all the parts on a clear
surface.
3. Thread nipple (C) into loop (F) until snug.
4. Thread other end of nipple (C) with loop attached into cross-
bar (D) until snug.
5. Place lock washer (B) over of nipple protruding through
crossbar and thread hex nut (A) onto nipple until tight.
6. Take this crossbar assembly and mount to ceiling junction
box with junction box screws (E) .Tighten screw securely
with screwdriver.
7. Use a pair of pliers to open one end link of the chain
provided, and connect to the fixture loop (J) . Close the link.
8. By measuring, determine correct number of links needed for
proper hanging height. Using pliers, disconnect and discard
remaining chain.
9. Lace the fixture wires through the chain.
10. Slip loop collar (H) over the chain, then do the same with the
canopy (G).
11. Open the other end link of the chain and hang the fixture on
the loop at the celling. Close the link.
12. Feed the fixture wires through the loop (F) , and nipple (C)
and
pull until taut.
CONNECTING THE WIRES (Fig.2)
13. Take the black wire from the ceiling junction box and the
smooth wire leg from the fixture and twist bare ands
together.
Twist wire connector onto end of wires untilsnug.
14. Repeat same process with white junction box wite and
ribbed
wire leg of fixture wire. NOTE: Twist wires together in the
Same direction you twist the wire connecto onto wires.
15. If your junction box has a grounding wire (green or bare
copper), attach this wire and the bare copper wire from the
fixture together as in step 13. If junction box has no ground
wire, attach the bare copper fixture wire to the junction box
with a screw.
16. Tuck these wire connections neatly into he ceiling outlet
box and then raise the canopy (G) all the way to the ceiling.
Raise the loop collar (H) and thread onto ceiling loop protrud-
ing through canopy.
17. Install the light bulbs in accordance with the fixtures
specifications.
NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE.
Your installation is now complete. Returm power to the
junction box and text the fixture.
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
D
E
F
H
J
CHAIN
G
A
JUNCTION BOX
(CEILING)
B
C