Golden Lighting 8106-10 CDB - Manual

Canopy Hex nut Cap
1ea Φ360*32H*0.8t 2ea Φ19*5tmm 1ea Φ23*6H*0.6t
Chain
Nipple or
Threaded rod
Wire connectors
2ea 10ft 1ea 4'18T*50L 3ea Orange
Chain
connector
Mounting strap Green screws
2ea 23.8*59mm 1ea 100mm*20mm 1ea Φ9*10mm
Deco Nut
Mounting
screws
1ea SΦ22*18H 2ea 8/32T*1-1/4"L
Part Needed Quantity
Part Needed Quantity
Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments
F IXTURE A SSEMBLY I NSTRUCTIONS
For Customer Service, contact the place of purchase to arrange for replacement parts.
NOTE: I NSTALL THE GLASS ASSEMBLY
AFTER THE FIXTURE IS HUNG.
1. By measuring determine correct number of links
needed for proper hanging height. Use a pair of
pliers to open one link of the Chain (J) then remove
the excess chain (J) and discard it.
2. Use Chain connector (R) to attach the Top loop
(K) to one end of chain (J) and close the connector
as shown. (disregard if the Top loop is already
attached to one end of chain)
3. Attach a Chain connector (R) to the top end of the
Chain (J). Repeat steps 1thru 3 for the second
chain.
8106-10 CDB
Read and review installation instruction sheet before
assembling the fixture.
Fig 1
Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are
missing or damaged, please note onthis sheet and contact the place of purchase to arrange for
replacement parts.
PARTS LIST Company Name:_______________________Co. Account #:_____________
to be filled out by retailer
PARTS & ASSEMBLY SHEET
This fixture assembled PO:__________ Date: ________
Fixture Name: Torbellino 8106-10 CDB