Golden Lighting 8106-FM CDB - Manual

Mounting
strap Mounting
screws
Wire connectors
1ea W25*100L*11H*1.5t 2ea 8/32T*1-1/4"L 3ea Orange
Hex nut Finial Green screws
2ea Φ9*3.5tmm 1ea Φ29*44hmm 1ea Φ9*10mm
Nipple Bottom cap
Rubber washer
1ea Φ12*125mm 1ea Φ70*11H*0.6t 1ea Φ18*1.0t
Part Needed Quantity
Part Needed Quantity
Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments
Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are
missing or damaged, please note onthis sheet and contact the place of purchase to arrange for replacement
parts.
PARTS LIST
Company Name:_______________________Co. Account #:_____________
to be filled out by retailer
PARTS & ASSEMBLY SHEET
This fixture assembled PO:__________ Date: ________
Fixture Name: Torbellino 8106-FM CDB
F IXTURE A SSEMBLY I NSTRUCTIONS
For Customer Service, contact the place of purchase to arrange for replacement parts.
NOTE: I NSTALL THE GLASS ASSEMBLY
AFTER THE FIXTURE IS HUNG.
1. Thread the Nipple (G) into the Coupling (E), and
then thread the Hex Nut (F) onto Nipple (G) until tight.
2. Install the light bulbs in accordance with the fixture's
specifications.
3. Place Glass Shade (H) over the Ceiling Pan (D).
The Nipple (G)shall protrude the bottom hole of the
Glass Shade (H).
4. While holding the Glass Shade (H) slide washer(J)
over Nipple (G) and thread Hex nut (K) until tight.
5. Slide Bottom Cap (L) over Nipple (G) and thread the
Finial (M) until tight.
(DO NOT EXCEED THE MAXIMUM WATTAGE RATING)
Fig 1
8106-FM CDB
Read and review installation instruction sheet
before assembling the fixture.
D
F
G
E
H
J
L
K
M