Golden Lighting 8107-SF WG - Manual

Assembly Instructions: 8107-SF WG (Torbellino)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the important
notes above. Shut off the power at the circuit breaker and
completely remove the old fixture from the ceiling, including the
old mounting strap.
Mounting strap (B) contains several pairs of threaded holes.
Find the pair of holes that matches the spacing of the holes
on the junction box. Two of mounting screws (A) should be
attached to mounting strap (B). You may need to tighten the
nuts (C) that hold these screws in place. Place mounting strap
(B) over the junction box so that mounting screws (A) are
pointing down. Secure mounting strap (B) to the junction box
with mounting screws (D) and a screwdriver. Tighten the screws
securely.
CONNECTING THE WIRES
Have an assistant support the fixture weight while completing
the wiring. Cut away excess wire. Attach the fixture’s wires to
the power supply wires from the junction box. Connect black to
black (or smooth); white to white (or ribbed); ground to ground
(green or copper). Twist the ends of the wire pairs together, then
twist on a wire connector. Make sure all twists are in the same
direction. If there is no ground wire (green or copper) from the
junction box, locate ground screw (E) on mounting strap (B) and
wrap the fixture ground wire around the green ground screw (E).
Use a screwdriver to secure ground screw (E) onto the mounting
bracket. Tuck all wires neatly into the junction box.
FINISHING THE INSTALLATION
Raise canopy (F) to the ceiling. Position mounting screws (A) so
that they protrude through the openings of canopy (F). Secure
canopy (F) with decorative nuts (G). To install the light bulbs
and glass shade, thread nipple (N) to the coupler on pan (U).
Install light bulbs in accordance with the fixture’s specifications.
Slide glass shade (O) over nipple (N) and slide plastic washer
(P) and steel washer (Q) up under the glass. Secure in place by
threading hex nut (R) onto threaded nipple (N). Slide bottom
cap (S) over the threads of nipple (N) and secure in place by
screwing finial (T) onto the threads of nipple (N).
Your installation is complete. Turn on the power and test the
fixture
.
CLEANING TIPS
Treat the fixture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
fixture with a clean lint-free cotton or microfiber cloth. Never spray cleaner directly onto the fixture. For deep cleaning, turn off the light
and remove the glass prior to cleaning. Hand wash glass with warm water and mild detergent. Dry with a lint-free or microfiber cloth.
P
Q
R
M
N
S
T
O
G
D
C
B
A
E
F
U
FLUSH
INSTALLATION
For Customer Service, contact
the place of purchase to arrange
for replacement parts.
BLACK
(Hot)
WHITE
(Neutral)
GREEN
(Ground)
HOUSE WIRES
SMOOTH
(Or Black)
FIXTURE WIRES
RIBBED
(Or White)
BARE COPPER
(Or Green)