Golden Lighting 8201-M1L SLV - Manual

Canopy 1ea Hex nut 2ea Nipple 2ea
Chain
1ea
6ft
Wire Connector 2ea
Mounting Strap
w/ ground
screw
1ea
Chain
Connector
2ea Mounting Screw 2ea
Canopy Loop
and Canopy
Loop Collar
1ea
Crystal draping
Ax20pcs
Crystal drops
Bx 6pcs
Part Needed Quantity
Part Needed Quantity
Reason why (missing, scratched, broken glass, bent, bad finish)
Comments
PARTS LIST
Read and review installation instruction sheet before
assembling the fixture.
8201-5P BLK/SLV
1. Measure to determine the correct number of chain links
needed for proper hanging height. Use a pair of pliers to
open one link of the Chain (A2). Then remove and discard
the excess Chain (A2).
2. Use one Chain Connector (A12) to attach one end of
the chain to the Top Loop (A) and close the chain. Feed
the fixture wires through the Chain (every three links) and
pull the wires until taut.
4. Slip Canopy Loop Collar (A11) over the chain. Then do
the same with the canopy .
5. To complete the installation, use the other chain
connector to attach the other end of the chain to the
Canopy Loop (A10) Close the chain connector.
6. Make sure the weight of the chandelier is supported by
the chain, not the electrical wire.
* You may now install the fixture.
Fig 1
Company Name:_______________________Co. Account #:_____________
to be filled out by retailer
Crystal drops are included in parts
bag. (see crystal assembly
instruction)
F IXTURE A SSEMBLY I NSTRUCTIONS
PARTS & ASSEMBLY SHEET
Fixture Name: Tetiva 8201-5P BLK/SLV
This fixture assembled PO:__________ Date: ________
Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are
missing or damaged, please note on this sheet and contact the place of purchase to arrange for
replacement parts.