Golden Lighting 8355 RBZ - Manual

Mounting strap
w/ ground screw
Threaded rod
1ea 3/4"X4" 2ea 3/8"*H45mm
Wire connnector Hex nut Deco nut (round nut)
3ea P3 Orange 2ea @3/8X3mm 1ea 3/8"*H9mm
Finial Sping washer Bottom cap
1ea Ø13*H9mm 1ea Ø15*H3mm 1ea 38*H28mm
Part Needed Quantity
Part Needed Quantity
Reason why ( missing, scratched, broken glass, bent, bad finish)
Comments
PARTS & ASSEMBLY SHEET
This fixture assembled PO:__________ Date: ________
Fixture Name: Multi-Family 8355 RBZ
Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or
damaged, please note onthis sheet and contact the place of purchase to arrange for replacement parts.
PARTS LIST
Company Name:_______________________Co. Account #:_____________
below to be filled out by retailer
For Customer Service, contact the place of purchase to arrange for replacement parts.
NOTE: I NSTALL THE GLASS ASSEMBLY AFTER
THE FIXTURE IS HUNG.
1. Attach the finial (N) to Threaded rod (L) and slide through
Bottom Cap (K)
2. Place the Glass Shade (M) flush with the Back plate (J) just
under the "L" shaped lip.
3. Slide Bottom cap assembly (K+L+N) into hole at the bottom
of Glass shade (M), with the threaded rod going through the
hole in bottom of fixture back plate and tighten with Hex nut
(O).
*If the glass does not sit flush with the wall remove the glass,
gently press the lip up bit to increase glass tension and
reinstall the glass.
4. Install the light bulb in accordance with the fixture's
specifications.
(DO NOT EXCEED THE MAXIMUM WATTAGE RATING!)
Fig. 1
Junction box screws
2ea #8-32N*18mm
8355 RBZ
Read and review installation instruction sheet before
assembling the fixture.
F IXTURE A SSEMBLY I NSTRUCTIONS
O
N
H
M
J
K
L
8355 PartsInstallation-20101005m.xls