Golden Lighting 9903-12 MG User Manual

Installation instructions, Warning! shut power off at fuse or circuit breaker

Advertising
background image

For Customer Service, contact the place of purchase to arrange for replacement parts.

CSA055312HALG1.DOC

INSTALLATION INSTRUCTIONS

Fixture Name: AUTUMN TWILIGHT 9903-12 MG
For Chandelier Light Fixture

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER

HANGING THE FIXTUREFig.1

1. Carefully remove the new fixture from the carton and

the yellow bag that holds all parts. Check that all parts

are included as shown in the illustration and parts list.

2. Shut off the power at the circuit breaker and remove

old fixture from ceiling, including the old mounting

strap.

3. The Mounting Strap (B) contains several pairs of

threaded holes, find the pair of holes that match the

holes spacing in your fixture Canopy (D) and thread

the Nipple (A) half way into the Fixture Mounting Strap

(B).

4. Attach the Fixture Mounting Strap (B) to the Junction

Box using the two Mounting Screws (C). Tighten the

Screws (C) securely with screwdriver.

5. Adjust correct length of cable needed for hanging

height. You may need to cut short the wire and

reconnect with transformer refer original mode.

CONNECTING THE WIRES (Fig.2)

6. Attach the power supply wires to the fixture lead wires

by connecting BLACK to BLACK (or SMOOTH) and

WHITE to WHITE (or RIBBED).

7. Attach the GROUND wire (GREEN or COPPER) from the

Junction Box and the fixture Ground wire to the green

Ground Screw on the Mounting Bracket (B) or connect

both wires together using the correct size of wire

connectors.

NOTE: Twist the wires together in the same direction you

twist the wire connector onto the wires.

8. Tuck these wire connections neatly into the Junction

Box.

FINISHING THE INSTALLATION (Fig.3)

9. Raise Canopy (D) to the ceiling and secure in place

by tightening the Deco Nut (F).

10. Install the light bulbs and crystals as per the fixture

assembly sheet.

YOUR INSTALLATION IS NOW COMPLETE. TURN POWER ON

AT TO THE JUNCTION BOX & TEST THE FIXTURE.

Fig.1

Fig.2

FIXTURE WIRES

SMOOTH

(or Black)

RIBBED

(or White)

BARE COPPER

(or Green)

HOUSE WIRES

BLACK

(Hot)

WHITE

(Neutral)

GREEN

(Ground)

JUNCTION BOX

(CEILING)

A

B

C

D

F

Advertising
Table of contents