Golden Lighting 9903-WSC MG - Manual

F For Customer Service, contact the place of purchase to arrange for replacement parts.
CSA055303WALG1.DOC
INSTALLATION INSTRUCTIONS
Fixture Name: AUTUMN TWILIGHT 9903-WSC MG
For Wall Mount Light Fixture
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
HANGING THE FIXTURE (Fig.1)
1. Carefully remove the new fixture from the carton
and the yellow parts bag. Check that all parts are
included as shown in the illustration and parts list.
2. Shut off power at the circuit breaker and remove
the old fixture from wall, including the old
mounting strap.
3. The Mounting Strap (A) contains several pairs of
threaded holes, find the pair of holes that match
the holes spacing in your fixture Back Plate (D) and
thread the two Fixture Mounting Screws(C) half
way into the Fixture Mounting Strap (A).
4. Place the Mounting Strap (A) over the Junction
Box so the Fixture Mounting Screws(C) are vertical
or horizontal, as required by the fixture type.
5. Attach the Fixture Mounting Strap (A) to the
Junction Box using the two Mounting Screws (B).
Tighten the Screws (B) securely with screwdriver.
CONNECTING THE WIRES（Fig.2）
6. Attach the power supply wires to the fixture lead
wires by connecting BLACK to BLACK (or SMOOTH)
and WHITE to WHITE (or RIBBED).
7. Attach the GROUND wire (GREEN or COPPER)
from the Junction Box and the fixture Ground wire
to the green Ground Screw on the Mounting
Bracket (B) or connect both wires together using
the correct size of wire connectors.
NOTE: Twist the wires together in the same direction
you twist the wire connector onto the wires.
8. Tuck these wire connections neatly into the
Junction Box.
FINISHING THE INSTALLATION（Fig.3）
9. After tucking these wire connections neatly into
the Junction Box and place the fixture Back Plate
(D) over the two Mounting Screws (C) and secure
the Back Plate (D) against the wall by threading
two Deco Nuts (E) over the two Mounting Screws
(C) until tight as shown on Fig.3.
10. Install crystals as per the fixture assembly
instructions.
YOUR INSTALLATION IS NOW COMPLETE. RETURN
POWER TO THE JUNCTION BOX AND TEST THE FIXTURE.
Fig. 1
Fig.2
Fig.3
JUNCTION BOX
D B A C
FIXTURE WIRES
SMOOTH
(or Black)
RIBBED
(or White)
BARE COPPER
(or Green)
HOUSE WIRES
BLACK
(Hot)
WHITE
(Neutral)
GREEN
(Ground)
JUNCTION BOX
D E C