Golden Lighting 9942-BA3 GL - Manual

Assembly Instructions: 9942-BA3 GL (Aiyana)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Carefully remove all of the contents from the carton. See the
important notes above. Shut off the power at the circuit breaker
and completely remove the old fixture from the wall, including
the old mounting strap.
Mounting strap (A) contains several pairs of threaded holes.
Find the pair of holes that matches the spacing of the holes on
the junction box and your fixture back plate. Two of mounting
screws (B2) should be attached to mounting strap (A). You
may need to tighten the nuts that hold these screws in place.
Pull the house wires through the center of mounting strap (A).
Place mounting strap (A) over the junction box so that mounting
screws (B2) are horizontal, and in alignment with the hole
locations on the fixture backplate. Secure mounting strap (A) to
the junction box with mounting screws (B2) and a screwdriver.
Tighten the screws securely.
CONNECTING THE WIRES
Have an assistant support the fixture weight while completing
the wiring. Cut away any excess wires. Thread the fixture wires
through the canopy. Attach the fixture’s wires to the power
supply wires from the junction box. Connect black to black (or
smooth); white to white (or ribbed); ground to ground (green or
copper). Twist the ends of the wire pairs together, then twist on
a wire connector. Make sure all twists are in the same direction.
If there is no ground wire (green or copper) from the junction
box, locate ground screw (E) on mounting strap (A) and wrap
the fixture ground wire around the green ground screw (E). Use
a screwdriver to secure ground screw (E) onto the mounting
bracket. Tuck all wires neatly into the junction box.
FINISHING THE INSTALLATION
Place the fixture backplate over mounting screws (B1) so that
they protrude through the holes in the front of the backplate.
Thread deco nuts (C) onto mounting screws (B1). Twist until the
backplate of the fixture is snug against the wall.
Install halogen bulbs, glass (S), and glass (L) in accordance with
the diagram above.
Bulb Note: Use a tissue or paper towel to hold the bulb and
push down into the socket. Oils and dirt can cause the bulb life
to shorten. Rubbing alcohol is recommended to clean the bulbs
when needed.
Place retaining ring (E) over the socket. Carefully slide glass (D)
over the socket. Cover the halogen bulb with diffuser (F).
Your installation is now complete. Turn on the power and test the
fixture.
CLEANING TIPS
Treat the fixture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
fixture with a clean lint-free cotton or microfiber cloth. Never spray cleaner directly onto the fixture.
For Customer Service, contact
the place of purchase to arrange
for replacement parts.
BLACK
(Hot)
WHITE
(Neutral)
GREEN
(Ground)
HOUSE WIRES
SMOOTH
(Or Black)
FIXTURE WIRES
RIBBED
(Or White)
BARE COPPER
(Or Green)
S
TOTAL
3PCS
L
TOTAL
3PCS S
L
L
S
S
L
A B2
B1
C
D
E
F