Golden Lighting 9903-M1L MG - Manual

For Customer Service, contact the place of purchase to arrange for replacement parts.
CSA055304DALG1.DOC
INSTALLATION INSTRUCTIONS
Fixture Name: AUTUMN TWILIGHT 9903-M1L MG
For Pendant Light Fixture
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
HANGING THE FIXTURE（Fig.1）
1. Carefully remove the new fixture from the carton and the
yellow bag that holds all parts. Check that all parts are
included as shown in the illustration and parts list.
2. Shut off the power at the circuit breaker and remove old
fixture from ceiling, including the old mounting strap.
3. Thread Nipple(C) into Canopy Loop (F) until snug.
4. Thread other end of the Nipple (C) with Canopy Loop
attached into Mounting Strap (D).
5. Place Lock Washer (B) over end of Nipple (C) protruding
through Mounting Strap (D) and thread Hex Nuts (A) onto
Nipple until tight.
6. Take this mounting strap assembly and mount to ceiling
junction box with junction box Screws (E). Tighten screw
securely with screw driver.
7. Unscrew the Canopy loop collar (H) from the Canopy
loop. Take the canopy and pass over the Canopy loop.
Approximately one half of the canopy loop exterior
threads should be exposed. Adjust until desired height is
reached. *the Canopy loop collar should fit snugly on the
Canopy loop after the canopy is installed. Remove
Canopy and Canopy loop collar.
8. Assemble the fixture and have an assistant or secure
support hold the weight of the fixture while you complete
the wiring connections.
9. Thread the fixture wires and ground wire of the
assembled fixture through the canopy loop (F) and
nipple(C) and chain (every three links) into the outlet box.
CONNECTING THE WIRES (Fig.2)
10. Attach the power supply wires to the fixture lead wires
by connecting BLACK to BLACK (or SMOOTH) and WHITE
to WHITE (or RIBBED).
11. Attach the GROUND wire (GREEN or COPPER) from the
Junction Box and the fixture Ground wire to the green
Ground Screw on the Mounting Bracket (B) or connect
both wires together using the correct size of wire
connectors.
NOTE: Twist the wires together in the same direction you
twist the wire connector onto the wires.
12. Tuck these wire connections neatly into the Junction
Box.
FINISHING THE INSTALLATION (Fig.3)
13. Raise Canopy (G) to the ceiling and secure in place by
tightening the Canopy loop collar (H) into the Canopy
Loop (F).
14. Install the light bulbs and crystals as per the fixture
assembly sheet.
YOUR INSTALLATION IS NOW COMPLETE. TURN POWER ON AT
TO THE JUNCTION BOX & TEST THE FIXTURE.
Fig.1
Fig.2
FIXTURE WIRES
SMOOTH
(or Black)
RIBBED
(or White)
BARE COPPER
(or Green)
HOUSE WIRES
BLACK
(Hot)
WHITE
(Neutral)
GREEN
(Ground)
JUNCTION BOX
(CEILING)
A
B
D
C
E
F
I
I
G
H
CHAIN
J