Heli-Max HMXE0810 - Manual (Page 12)

12
❏ 2. Cut the supplied silicone
tubing into eight 1/8” [3mm]
pieces. Please keep in mind
that carbon rods are
dangerous to handle and
splinter easily. Using pliers,
carefully slide the silicone
tubing onto the carbon rod
approximately 4” [102mm].
Now install a foam ball
followed by a washer. Using
pliers, install the last piece of
fuel tubing. Repeat this step
for the other three balls.
GET THE MODEL READY TO FLY GET THE MODEL READY TO FLY
ELECTRIC MOTOR WARNING
Electric-powered models
are very dangerous. Please
remove the pinion gear
or unplug the motor while
working on the model. If your
helicopter uses an electric
tail motor, make sure it is
unplugged as well.