Heli-Max HMXE0810 - Manual (Page 26)

26
MAIN SHAFT INSTALLATION
Using the 1.5mm hex
wrench and pliers to hold
the nut, re-install the lower
main shaft bolt.
Insert a 1.5mm hex wrench
into the main shaft collar
set screw. While pushing
downward on the main shaft,
pull upward on the main
shaft collar and tighten the
set screw. There should be
no vertical movement in the
main shaft once you have
completed this step.
Slide the main rotor head
block back onto the main
shaft. Make certain the fl at
spot inside of the head block
is aligned with the fl at spot on
the main shaft. Use a 1.5mm
hex wrench to re-install the
2mm bolt head bolt.
GOOD LUCK AND GREAT FLYING!