Heli-Max HMXE0810 - Manual (Page 24)

24
New spindle installation. Ap-
ply threadlocking compound
to one of the 2mm screws.
Slide the 2mm washer onto
the screw and thread it into
the new spindle. Slide one
of the blade grips onto the
spindle followed by one of
the dampening spacers.
Using a 1.5mm hex wrench,
slide the blade grip and
spindle assembly through
the head block. Make certain
the O-rings are properly
seated and do not slide out
the other side.
Place the other dampening
spacer and blade grip onto
the spindle. Apply thread-
locking compound to the
remaining 2mm spindle
screw. Slide a 2mm washer
onto the screw and install
into the spindle. Using two
1.5mm hex wrenches tighten
the spindle bolts.
Snap the ball links onto the
blade grips and re-install the
main blades.