Heli-Max HMXE0810 - Manual (Page 8)

8
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS
INSTALL BATTERIES IN THE TRANSMITTER
❏ 1. Remove the battery
cover from the back of the
transmitter and install four
“AA” batteries. Check the
polarity of each battery
b e fo r e r e p l a c i n g t h e
battery cover.
❏ 2. Turn on the transmitter
using the power switch as
shown above. Check the
LED on the front of the
transmitter. Only the Green
LED should be on. If the LED
is fl ashing, then the batteries
need replacing.
CHARGING THE FLIGHT BATTERY
IMPORTANT!! Always remove the LiPo battery pack from the helicopter
and charge the battery in a location that is fi reproof. Never leave the
battery unattended while being charged! If the battery becomes hot,
starts to smoke or begins to swell, immediately disconnect the battery
from the charger and carefully move the battery to a fi reproof location!