Heli-Max HMXE0810 - Manual (Page 23)

23
SPINDLE REPLACEMENT
Before starting, make note
of the 2mm nut used on the
bottom of each blade grip.
When removing the blade
bolt, press upward on the
nut to ensure it remains in
the grip.
Remove the blade grip
bolts using the 1.5mm hex
wrench. Then, remove the
blades from the helicopter.
Use a 1.5mm hex wrench to remove a spindle screw. Remove the linkages from
the blade grips. On the side where you removed the spindle screw, carefully
remove the blade grip by pulling outward. Remove the dampening spacer. Pull
on the other blade grip and remove the spindle and blade grip. If the O-rings
come loose, simply press them back into the head block.