Heli-Max HMXE0250 - Manual (Page 14)

LANDING GEAR
Bag 6 Contents: 3x20mm SHCS (4), Plastic Spacers,
3mm Nylon Lock Nut (4), 3x4mm Set Screws (4)
❏
1. Insert a 3x20mm SHCS through the underside of the
landing gear strut. Slide a plastic spacer on the top and
insert the screw into the front frame hole. From the top,
install a 3mm nylon lock nut and tighten the bolt. Repeat for
the other side and the rear strut. If the front skid does not
clear the cylinder head on your engine, then simply mount
the front skid in the aft hole.
❏
2. Slide the landing gear skids through the struts from
the front. Leave approximately 1" [25mm] protruding from
the back.
❏
3. Install the four 3x4mm set screws into the inside of the
struts. These are used to lock the struts to the skids. Please
be careful not to overtighten.
GYRO MOUNT AND TAIL ROTOR SERVO MOUNT
Bag 4 Contents: Tail Rotor Servo Mount, Linkage Rods,
Tail Rotor Pushrod Coupler, Servo Retainers
❏
1. Install the gyro and servo mount using four 3x30mm
SHCS and four 3mm nylon lock nuts as shown above. Push
the boom all the way forward into the frame while turning the
rotor head before tightening the bolts down completely.
Please make sure the boom is far enough forward to
engage the tail drive.
14