Heli-Max HMXE0250 User Manual
Page 22
❏
Futaba T7CH: Select the [GYRO] menu. Enable the
function and set the switch to [SW-E] (Flight Condition Switch).
Set all positions to [A 60
%
] which is AVCS (Heading Hold) and
60
%
gain.
❏
Futaba T9CH: Select the [GYRO] menu. Enable the
function and set the switch to [SW-E] (Flight Condition Switch).
Set all positions to [A 60
%
] which is AVCS (Heading Hold) and
60
%
gain.
THROTTLE CUT
7CH
9CH
❏
Futaba T7CH: Select the [TH-CUT] menu. Enable the
function and set the switch to [SW-H], using the following
settings: [RATE –10
%
] — [THR> 5
%
]
❏
Futaba T9CH: Select the [TH-CUT] menu. Enable the
function and set the switch to [SW-H], using the following
settings: [RATE–10
%
] — [THR>5
%
] — [POSI->DOWN]
HOVER AND THROTTLE TRIMS
Since the hover and throttle trims operate only in normal
flight mode, it’s best to disable them and make changes with
mechanical adjustments.
HI-LO PITCH TRIMS
Set the “CONTROL” to null on both HI and LO pitch trims.
THROTTLE CURVE
6EXH
7CH
9CH
❏
Futaba T6EXH: Select the [N-TH] menu. Set Point #1 to 0
%
.
Press (Select) to move to the next point. Set Point #2 to 25
%
,
set Point #3 to 50
%
, Point #4 to 75
%
and Point #5 to 100
%
.
❏
Futaba T7CH: Select the [TH-CRV(N)] menu. Press the
button until you are editing Point #1. Use the rotary dial
to set it to 0
%
. Press the
button to move to Point #2 and
set it to 25
%
. Set Point #3 to 50
%
, Point #4 to 75
%
and
Point #5 to 100
%
.
❏
Futaba T9CH: Select the [TH-CV/NOR] menu. Set Point
#1 to 0
%
. Press the
button to move to Point #2 and set
it to 25
%
. Set Point #3 to 50
%
, Point #4 to 75
%
and Point #5
to 100
%
.
22