Heli-Max HMXE0250 User Manual
Page 20
6EXH
7CH
9CH
❏
Futaba T6EXH: Press the (MODE) button until the screen
shows [D/R ch1 100
%
]. Press the (Select) button until the
screen shows [EXPO CH1 + – 0
%
]. Use the
button and
decrease to –30
%
. Flip the Dual Rate switch on the
transmitter and adjust the low/high rate also. Repeat this for
the forward/aft (CH2) and tail rotor (CH4).
❏
Futaba T7CH: Select the [D/R,EXP] menu. Press the cursor
button to move down to [EXP + – 0
%
]. Use the rotary dial
to set the value to –30
%
. Cursor back up to [CH> 1-AIL] and
turn the rotary dial clockwise one position. You will notice the
arrow next to AIL changes. This is the low rate setting for CH1
AIL; set it to –30
%
. Turn the rotary dial clockwise one position
and the display will change to [CH> 2-ELE]. Continue setting
the high and low rate exponential to –30
%
for forward/aft cyclic
(CH2) and tail rotor (CH3).
❏
Futaba T9CH: Select the [*D/R,EXP] menu. Press the cursor
button to move down to [EXP + – 0
%
]. Use the rotary dial
to set the
%
to -30
%
. Cursor back up to [CH> 1-AIL] and turn
the rotary dial clockwise one position. You will notice the arrow
next to AIL changes. This is the low rate setting for CH1 AIL; set
it to –30
%
. Turn the rotary dial clockwise one position and the
display will change to [CH> 2-ELE]. Continue setting the high
and low rate exponential to –30
%
for (CH4) tail rotor.
SERVO REVERSING
6EXH
7CH
9CH
WARNING: These settings are ONLY for Futaba radios using
Futaba servos. Please double-check the settings before flight
to be absolutely sure they are correct.
❏
Futaba T6EXH with Futaba Servos: Select the [REVR]
menu. Reverse channels 3-Throttle and 4-Tail Rotor.
Channels 1, 2, 5, and 6 should remain as [NORM]
❏
Futaba T7CH with Futaba Servos: Select the [REVERSE]
menu. Reverse channels 3-Throttle and 4-Tail Rotor.
Channels 1, 2, 5, and 6 should remain as [NORM]
❏
Futaba T9CH with Futaba Servos: Select the [REVERSE]
menu. Reverse channels 3-Throttle and 4-Tail Rotor.
Channels 1, 2, 5, and 6 should remain as [NORM]
20