Heli-Max HMXE0250 - Manual (Page 16)

❏
4. The collective and throttle servos are mounted on the
inside of the frame. Slide the throttle servo into the frame as
shown above. Install a 2.6x10mm screw and use a plastic
servo nut behind the servo. Tighten the 2.6mm screw until the
grommet begins to compress. Install the other three screws
and the plastic servo nut on the opposite end of the servo.
❏
5. Install the collective servo using four 2.6x10mm screws
and two plastic servo nuts. Re-install the servo frame with
the five screws you removed earlier.
❏
6. Install the forward/aft cyclic servo using four 2.6x10mm
screws. Note servo arm direction.
❏
7. Install the left/right cyclic servo using four 2.6x10mm
screws. Note servo arm direction.
❏
8. Install the tail rotor servo as shown using four 2.6x10mm
screws and two plastic servo nuts.
BATTERY, RECEIVER AND GYRO
❏
1. Wrap the battery with 1/4" foam. Use electrical tape to
attach the foam to the battery. Place the battery on the front
tray and attach it with electrical tape.
❏
2. Place a piece of 1/4" foam on top of the battery and place
the receiver on top of the foam. Wrap lightly but securely with
electrical tape, leaving room for the foam to absorb vibration.
16